How do you like the 4snow tires? Are they worth the money and do you run them year round? Do they actually do good in the snow. So the xr cam is a direct swap?
I like them. I run them all year. The ride is much better than most knobbies. They do awesome in the snow but they better! Cam is a direct swap. Still available new from Honda!
@jasonmushmansixtyfive its just a beater I'm working on was thinking about maybe an aftermarket cam or should I stay away. And maybe crf 230 exhaust. I'm on a budget but that whole exhaust is like 1/4 of the muffler on my ltz400. Did you lose any bottom end. Like when your just trying to put around up a hill real slow or anything?
Web Camshafts make like 6 different cams. They hard weld new material on the stock cam then re-grind the cam to their specs. Only bad part about that is you have to send rockers to be serviced in order to last with aggressive grinds. That along with required heavier valvesprings it gets pricey in a hurry. The cam I installed is for a Honda Xr200 and can be bought new @ any Honda dealer. I checked and the 185 uses same valvesprings so that's not an issue.
I was a piece of wire to hold the flywheel on the mark.
nice one !!
ps; i lost my pull start bolt like 3 times too hahaha
I figure it's because of the insane RPM's these beasts are able to attain...
@ Yeah , i push mine pretty hard too🤣🤣
How do you like the 4snow tires? Are they worth the money and do you run them year round? Do they actually do good in the snow. So the xr cam is a direct swap?
I like them. I run them all year. The ride is much better than most knobbies. They do awesome in the snow but they better!
Cam is a direct swap. Still available new from Honda!
@jasonmushmansixtyfive its just a beater I'm working on was thinking about maybe an aftermarket cam or should I stay away. And maybe crf 230 exhaust. I'm on a budget but that whole exhaust is like 1/4 of the muffler on my ltz400. Did you lose any bottom end. Like when your just trying to put around up a hill real slow or anything?
@@joshuawray5917 it still putts around fine. Any bottom end loss isn't noticeable with the butt dyno.
@@jasonmushmansixtyfive how about an aftermarket cam? Did u use oem?
Web Camshafts make like 6 different cams. They hard weld new material on the stock cam then re-grind the cam to their specs. Only bad part about that is you have to send rockers to be serviced in order to last with aggressive grinds. That along with required heavier valvesprings it gets pricey in a hurry.
The cam I installed is for a Honda Xr200 and can be bought new @ any Honda dealer. I checked and the 185 uses same valvesprings so that's not an issue.