Hello good day Kickback Garage for work reasons I reappear! Today I have placed the rapid flow! up to 3rd it picks up laps very well, up to 4th it holds on for a moment but starts to fail and runs out of fuel, could it be the carburetor float? He wears a 26, I don't know what else to try, thanks for your time
Hello Kickback!! I have a problem and nobody knows how to guide me, I hope you can help me, I have a 200 lambretta with a reed box, clubma exhaust, 26 carburetor, I have fitted an 18-tooth pinion with a 46 crown, perfect up to third speed, when I put fourth it dies! I changed to a 16 but I don't see it very well, it does less than what ratio would you recommend? From already thank you very much, greetings
, i will do that! first I will place a fast fluid grout and check the carburetor, and finally I will change the 46 x a 47, thank you very much for your help
First time i have ever heard a man complain about being too tight! HAHA you an steel weasel are awesome contnet providers
Casa Performance make some quality kit. I fitted the new front drive on my rebuild.
Quality kit, pricey but saves a load of hassle 😉that’s the front sprocket system 😁
Very nice , thank you very much. That information and video was worth it's weight in gold .
Mark from Maryland
Hello good day
Kickback Garage for work reasons I reappear! Today I have placed the rapid flow! up to 3rd it picks up laps very well, up to 4th it holds on for a moment but starts to fail and runs out of fuel, could it be the carburetor float? He wears a 26, I don't know what else to try, thanks for your time
You need a 300 or 350 float jet. The ones dellorto come with are too small.
Merci pour la video .je decouvre des super choses .thank you very much.
Philippe .
The steel weasel says it’s better to pull the chain down as it gives better contact onto the sprockets with 5-10mm movement on the bottom chain??
I use both methods but it doesn't make any difference because the chain runs backwards and torque is applied at the lower cercumference.
Beautiful bit of kit there...
Hello Kickback!! I have a problem and nobody knows how to guide me, I hope you can help me, I have a 200 lambretta with a reed box, clubma exhaust, 26 carburetor, I have fitted an 18-tooth pinion with a 46 crown, perfect up to third speed, when I put fourth it dies! I changed to a 16 but I don't see it very well, it does less than what ratio would you recommend? From already thank you very much, greetings
Hi Claudio, which gearbox do you have?
Hello Kickback!! Thanks for answering, I have an original gearbox from the one that comes with the 200cc from Spain.
of origin brings a 15-46
@@murdock8018 Your gearing is too tall. You should swap back to original 15x46 (4.89 final primary) or even better, 16x47 for 4.99 final)
, i will do that! first I will place a fast fluid grout and check the carburetor, and finally I will change the 46 x a 47, thank you very much for your help
Have you used the af rayspeed tubeless rims?
Sorry, no.
No oil thrower washer on the casa case ?
None needed
The drive side bearing isn't lubricated by gearbox oil on the casa case. That's why the thrower isn't needed.
Best april fist. Ever!
ooh he loves a fist!
🤣