Cheers for this mate. Was literally just trying to pull the workings out. But couldn't do it. It's just the vibration mode working on mine now. No sound, but everything seems fine on the board etc.
If you take the centre rubber grommet off the power button, you will expose the plastic button which makes it easier to depress and slide out , and you can see it housed properly when you slide it back in.
When you pulled the circuit board did you hold the switch down on the garret pin pointer ? and was you holding the switch down when putting it back together
I have the knock off version of your pinpointer. I'll take mine apart again and double check those connections. Had it working for a bit, but then it started sounding off randomly.
Well I went back over the green board with a jewelers mask and found some corrosion on the backside of the green board. With a little baking soda with water, cleaned it up and now it's working as it should. Although I won't be taking it back in the water. Thanks for the video.
Life saver Thanks - will try to do mine tonight
Cheers for this mate. Was literally just trying to pull the workings out. But couldn't do it. It's just the vibration mode working on mine now. No sound, but everything seems fine on the board etc.
If you take the centre rubber grommet off the power button, you will expose the plastic button which makes it easier to depress and slide out , and you can see it housed properly when you slide it back in.
Yo how u got everything out I only got the mother bord out
Nice Job !!!
Oh boy. The new ones does not seem much different from the older model.
How long did you have this one before this happened?
3 years ish
When you pulled the circuit board did you hold the switch down on the garret pin pointer ? and was you holding the switch down when putting it back together
Yes
Good stuff man 👍🏽🤓
Thanks for the visit
I have the knock off version of your pinpointer. I'll take mine apart again and double check those connections. Had it working for a bit, but then it started sounding off randomly.
Well I went back over the green board with a jewelers mask and found some corrosion on the backside of the green board. With a little baking soda with water, cleaned it up and now it's working as it should. Although I won't be taking it back in the water. Thanks for the video.
Thx for the video
You bet
Thanks. Fix my Vibro. 😁
Hello I have a question. How to fix a gp pointer that is always beeping?
I’m sorry I’m not sure after thinking about it I would think maybe u have corrosion on the board
My pin pointer its not vibrate
Kurwa stary dziękuję za ten film, uratowałeś moją marchewkę!!