So I cut out all the original stuff first. Then positioned the steering wheel and column with the dash and seats in. Once I had the location set, I reinforced everything and welded it up.
The marshall gauges have their own sending units or they connect to sources from the engine. I am using a Holley Terminator Max X for engine and trans management and they send signals for tach and etc.
I screwed the front down using the factory screw locations on the console and made 18-20 gauge sheet metal brackets and welded them to the tunnel. You can screw the brackets on too.
Nice work! Some voice over during the time lapse would be cool. Give us a little insight on the what and why of what you’re doing.
Thanks! I sure will on the next one!
The Camaro rear seats with brackets fit pretty well in the Chevelle's
I agree!
How the steering go wheel in👌👌👌
Thanks for the comment. I made a mount for the Camaro steering column to bolt it in.
I love watching the progress bro!
Thanks!
Beautiful work
Thank you very much!
Awesome job. One question how did you fit in the gen v steering column?
I am doing almost exactly the same to a 1978 Camaro in Denmark 😊
So I cut out all the original stuff first. Then positioned the steering wheel and column with the dash and seats in. Once I had the location set, I reinforced everything and welded it up.
Amazing work Sig!
Thanks bro!
Very nice. Any videos on getting the dash in?
Sorry I don’t have any videos of installing it.
I’d like to see how that dash went in
I didn’t record the install process fully, I I think there are some clips of it going in on my TikTok channel
How did you connnect neutral safety/ back up light switch for that newer shifter?
The shifter still has the sensor and wiring. I plan to connect to it. It has to be powered properly to unlock for shifting out of park
Hey guy, just subd, can you tell me about those door handles. I wanna do that to my 68, any downsides.
Sorry for the late reply. I love the build quality. They are from Kindig
What brand and part number is that bead roller?. Price.?
Thanks for the reply. It’s the Eastwood elite powered bead roller. I think it’s 27”
love the video maybe add some fair use music over your timelapse. other than that amazing video!
Thanks Vance! I’ll look in to that
How did you remove this dashboard I could get it removed from the Camaro
Hi Vic. I cut out the factory dash on the Chevelle.
how did you get the gauges to work?
The marshall gauges have their own sending units or they connect to sources from the engine. I am using a Holley Terminator Max X for engine and trans management and they send signals for tach and etc.
excellent!
Thanks! Appreciate that Peter!
Yeah , you can mig weld, but you did nt show HOW you installed the console
I screwed the front down using the factory screw locations on the console and made 18-20 gauge sheet metal brackets and welded them to the tunnel. You can screw the brackets on too.
Show me WHERE to BOLT IN my Center console in my Chevelle
It really depends on shifter location and how much you cut off the dash to make it work