Nice! So would you also radius/chamfer the top edge of the cylinder bore as well? And would you radius the outer edge of the combustion chamber in the head as well? I was wondering if you have the two radius‘ed edges meet like that, if it had a little radius at both mating surfaces could that cause issue with increasing the probability of detonation with essentially a tiny “pocket” at the edge where they meet the head gasket?
Good job.
Thanks for sharing.
Take care, Ed.
Nice! So would you also radius/chamfer the top edge of the cylinder bore as well? And would you radius the outer edge of the combustion chamber in the head as well? I was wondering if you have the two radius‘ed edges meet like that, if it had a little radius at both mating surfaces could that cause issue with increasing the probability of detonation with essentially a tiny “pocket” at the edge where they meet the head gasket?