Would be nice , BUT i have held of as the whole bed gets covered in aluminium chips and can interfere with the touch touchoff plate, and it may cause issues with a tool rack too. Happy to test if you want to send me one 😉
You can measure and enter your tool length offset into your tool table. Then, when the ATC spindle picks up a tool, it will apply, then knew tool offset. There is no need to probe the tool. Have a play around with adaptive toolpaths, easier on the tool. Turned out very nice 👍
Dan you definetly need an ATC spindle in your life 🤣
Would be nice , BUT i have held of as the whole bed gets covered in aluminium chips and can interfere with the touch touchoff plate, and it may cause issues with a tool rack too. Happy to test if you want to send me one 😉
You can measure and enter your tool length offset into your tool table. Then, when the ATC spindle picks up a tool, it will apply, then knew tool offset. There is no need to probe the tool. Have a play around with adaptive toolpaths, easier on the tool. Turned out very nice 👍