Liebert Compressor Change Out - HVAC

Replaced a compressor on a Liebert Wall Unit.
First recovery an refrigerant.
Second cut the liquid and suction line of the old compressor/drier and unbolt the compressors legs.
Third remove the compressor.
Fourth put in the new compressor and bolt in the legs.
Fifth solder in the new drier, liquid line and suction lines to the compressor. Make sure to have nitrogen running while doing this.
Sixth perform a nitrogen test and use bubbles on all soldered joins.
Seventh pull a vacuum to at least 500 microns and have it hold for at least 15 minutes (should not go above 1000 microns).
Eighth add in recovered refrigerant to the system. Look at your nameplate for the correct amount that needs to be added.
Ninth check pressures,subcooling, superheat and Delta T.

[@chesstime356]

Hello buddy, thank you for your sharing make sure to make longer videos if you can I know you are busy still appreciated thanks again. I will be seeing your videos no matter what

[@Davidandgoliathhvac]

Thank you for your support!