2017 Ford Edge - Park Brake Malfunction - C1034 C2007 C2008
Вставка
- Опубліковано 10 лют 2025
- In this video we shall be diagnosing and fixing a 2017 Ford Edge. The vehicle has a park brake malfunction warning and an inoperative park brake. Scanning the vehicle shows codes C1034 and C2008 but could easily have been c2007. This system (and fault) also applies to Ford Mondeo Mk5, Ford Fusion, Escape, Explorer and Kuga.
Please visit my Amazon store
www.amazon.co....
#c1034 #c2008 #c2007
======================================================================
Please subscribe to my channel and hit the notification bell for updates.
=============================================
/ carlton8571
=============================================
Facebook: / skodayoda
=============================================
eMail - sydiagnostics2019@gmail.com
=============================================
If any one of my videos has helped you out in any way, then please consider donating to support this channel to keep making and improving the content..
===============================
www.paypal.me/...
===============================
Great example off testing and not guessing! Excellent job Steve!
Cheers Dan
Diagnostics - the difference between tomorrow's technicians and yesterday's fitters
Thank you for the step by step diagnostics on troubleshooting this problem. I just had the same issue with dash light on/codes on a 2017 Ford Edge AWD. Initial diagnosis revealed the driver's side harness broken. After some discussion, the customer decided to replace both sides as a preventive measure. I replaced both drivers & passenger side rear park brake actuator harnesses. The part # for drivers side harness is: H2GZ-14A411-A, US price was $43.83 from Ford dealer parts dept. Passenger side harness part #: H2GZ- 14A411-B, US price $47.33 Great video, just posting part/price info for US viewers asking for part numbers. Thanks again for taking the time to make this video.
Thank you so much for this
Superb video I had the same issue and just replaced the harness today all fixed! Happy days
My stepdad had the parking brake issue on his 2017 Edge.. Watched your video because it matched the symptoms that he described. Low and behold, once we isolated which side was the problem, we followed the trouble shooting you demonstrated and it showed the harness to be bad on the LR. Untaped and unloomed the harness, and sure enough there was a small break in the wire due to corrosion. We were able to repair it and it fixed the problem. Thank you for the very informative video. If you could show or post the part number(s) for what you replace, these videos will be even more invaluable than they are now. Thanks again
I thought I'd put the part numbers for the harness. I'll look into it and update
Thanks for the comments
@@SYDiagnostics Where is the part#?
Great job. just had this exact concern this morning and it broke in that exact location
Good to see you back. Thanks for taking the time to video.
The good old Green crusties Steve , it's a good job we dont live in the salt belt area of the USA if that's what happens here , modern junk is coming out of factories over here , with parts that are not up to the longevity required from the public , it's ok if it's under warranty, but many will have to pay for the repairs , great video 👍👍👍
Great video as always and best of all that joyful moment when you find the culprit and you know that’s the fix
Great just great take care and all the best
Nice one SY , great to see you back 👍
Thank you thank you thank you!!!! I had one that was driving me mad trying to figure out the issue. I had power and ground. But now I know it was just shorting out. And the wire was defiantly broken, had rocks stuffed in the wire. Very neat
Nice one, good to see you back 👌
Missed your video’s.please your back steve
Spot on as always bud. Test not guess 👌
Cheers Dan.......you need to get back on it
@@SYDiagnostics dealership life, as you know mate makes it alot easier said than done 😂
Good video , well explained and good fix , nice one
Thanks 👍
Great job
Where ya been Steve. Glad your back
I had a few issues regarding the channel and its content, plus i've been moving house.....thanks for the support
Very interesting to see that corroded wires seem to be so common fault source.
It’s too often corroded wire across all brands either cheap plastic insulation or poor quality thousands times recycled copper metal
For example take wiring from old cars insulation cracked perished but wire itself gone dark but still solid
Same with the steel seen two year old car with subframe rotted through that does say a lot about todays carmakers
Another great video.
I appreciate that
and with a new harness , you will end up with the same error again because Ford does not know how to properly make a harness lol. crazy but good find just the fix is a bandaid to a broken arm.
Good logical approach, Top work as always. Not seen much from you lately or am I missing something?
Hi, I've not done any videos for a few months. Thanks for the support
Always keep your car clean don't let all that road salt and dirt and grime pile up on your electronics. There's only so much the connectors can keep out with those little rubber seals!
The vehicle that I just repaired was very clean all over, especially the underside. It was a 2017 Edge Titanium AWD with 140,000 miles. I found the wire broken in the bend, where it flexed the most due to the travel of suspension. Keeping the car clean underneath may help, but my guess is that they'll eventually break due to the flexing from suspension travel.
Ok well you showed me the problem good. I need to know how to disengage it cause the vehicle is stranded.
You can apply 12v and ground to the motor, one way will release it, reverse to apply
At 8:34 cant you just strip, twist then a bit of masking or gaffa tape?
Hope u r ok and family 👍
Fine thanks
Missed u pal 😛😛😛
so the solution , more permanent is to stop the corrosion , this is where dielectric grease comes in , you place some in the harness clips and that impedes water from getting in and causing corrosion. Its not a permanent solution but better than just a replacement.
This is happening to our 2017 Ford Edge Titanium. We have brought it to dealership twice and it just started happening again. They haven't replaced anything and claimed water was getting in the windshield. The windshield was replaced a while back so maybe they're telling the truth. We have a ways to drive sometimes with our baby and the incessant beeping really gets to us. I don't think we'll ever get another Ford.
Alan Howett had a very similar issue on a mk5 Mondeo in his latest video
yeah i saw it, i've seen this a few times myself, but had a logical approach
good video, thank you.
i have a doubt ,
What is P CAN in ford?
I'd imagine it's powertrain can. But I know it as hs can
@@SYDiagnostics We can find that in 2017 Ford GT vehicle dynamic suspension wiring diagram.
@@FACTS.INFINITY.. looking to me that its a private can network
my ford fusion 15/16 awd 2.0 says park break malfunction, service required, how do i fix this ?
Thanks for the very helpful video. The same harness cable needs replacing on my 2017 Ford Kuga. Is there a item number or something for this part? I’ve tried searching for it online to no avail. Any help would be grateful. Thanks
there should be a sticker on the harness with the number on it
@@SYDiagnostics I will take a look. Thanks for responding 👍🏼👍🏼
@Seii-FPV in the UK the ford part number on a 2018 Edge for the left hand harness is 2172262 and the right hand harness is 2172274. Im afraid though that in other markets Ford use different part numbers . The engineering numbers are H2GT-2B54-AA & H2GT-2B54-BA these may help
Will this fall under warranty will dealership fix for free😊
Currently in the middle of woods hiking when this malfunction message popped up. Parked on a dirt hill, engaged the parking break. It took multiple tries hitting the parking break switch to get the brakes to release. Thought I was gonna have to get a tow truck to come out in the woods.. hopefully I’m having the same issue with a broken wire. Not sure how the parking brake would release if the connection is broken?
My message states “limited function”.
@@freedomordeath1216hat was the issue as I have one tire fully locked 😢
@@MohamedAhmed-dw9zh did you get it to release?
@@MohamedAhmed-dw9zh I spammed the parking break switch probably 4 or 5 times. It finally released. I haven’t used the parking break since.
So I can’t fix it at home is what you’re saying ?
What’s the estimated cost for this repair?
Hello how do I pull up Ford codes? Or what if I have an error message with no error code
You'll need a diagnostics machine capable ir reading all the systems. I use Forscan when not using the dealer tool
Same thing happened to my wife's edge cost me $350 at the dealership now its doing it again 🤬
Bring back the traditional manual hand brake no more cost to car owner. Compare to this Crazy and idiotic idea epb
What's the part #
Idiot Ford why they replace the traditional manual hand brake compare to this crazy idea epb.which is another investment to car owner. Manual hand brake long last and no problem even 200 yrs or more
FoMoCo P/N H2GZ-14A411-B (PassengerSide).UA-cam search led me right to your post. Precisely my problem exactly, walked through your test steps and FoMoCo dealer had 4 in stock (imagine that) for $72.00 cdn taxes in.
Thanks so much!!
Great video, nice to see you back 👍
What's the part #
Best contacting your local dealer.
There's a question by Simon G where I give the uk part numbers