We got the machine at my job and I was looking for a video that explains all this because I want to keep it all clean and ready to go excellent explanation Thanks!
The effectiveness of the floor scrubber has everything to do with the clint's willingness to use the detergent solution! Spot cleaning might be more effective with a concentrated cleaner to dissolve accumulated grease and grime?
The one I use for work, only seems to clean in narrow lines but yours seems to be almost the width of the machine. Is there an adjustment that needs to be made?
I was watching your video as you were cleaning it out? When you're done with the machine don't you have to take the pad off the machine, because if you don't the pad will form to the machine?
The lever on the right side just above the disc housing push it down. Then, back up the scrubber and the pad will be on the disc. Peel it off and install a new one. Wrap the pad around the center triangle. Reinsert pad under the disc housing, align with teeth and reinstall disc. Good luck!
The detergent has no time to do it's job this way. First wet the floor without hoovering. Wait a few minutes, so the chemicals can work. Then clean of with hoover on. After that you should neutralise the floor. Source: Kärcher dude.
You may have a clogged solenoid screen. Lower Right hand side there is a rubber flap. Open the flap and unscrew the small grey cover and underneath is the screen. If you have a full tank use your water control valve to manage water volume when opened
@@cyranox90 well...many things are made in China. Who knows for sure. Open the yellow cover on the front like in the video. There is a full line ...the flat area.
Great demonstration. Thank you. Live in Denmark in Europe, far away but still this video made a difference :)
We got the machine at my job and I was looking for a video that explains all this because I want to keep it all clean and ready to go excellent explanation Thanks!
Excellent video! Thank you. Now I feel confident purchasing one of these units.
It was very helpful video. Now I know how to work the machine at work.👍
instablaster...
Great job by the way
The effectiveness of the floor scrubber has everything to do with the clint's willingness to use the detergent solution! Spot cleaning might be more effective with a concentrated cleaner to dissolve accumulated grease and grime?
Thanks for sharing!!
❤🎉
do these machine clean tuff dirt such as gum, rubber marks, etc. ?
@@spectator6656 The pads will do that but if too much gum is on the pad you’ll have to replace it. No issues with dirt etc.
Excelent
I love this machine I use one at work, this was excellent thank you 😊👍
What height is best for the squeegee???
The best height is just dragging the floor should get you 95-99% water vacuumed. Have fun!
WARNING!!! Flammable materials or reactive metals can cause explosion or fire. Don't use flammable materials or reactive metals in the tanks!!!
The one I use for work, only seems to clean in narrow lines but yours seems to be almost the width of the machine. Is there an adjustment that needs to be made?
Yes, you can adjust the side brushes and the bottom brush. Seek help from where you purchased it from. They can do this as needed.
I was watching your video as you were cleaning it out? When you're done with the machine don't you have to take the pad off the machine, because if you don't the pad will form to the machine?
You can but if you raise the nose with the lever you won't smash the pad to the floor. Good question!
How do you change the pad?
The lever on the right side just above the disc housing push it down. Then, back up the scrubber and the pad will be on the disc. Peel it off and install a new one. Wrap the pad around the center triangle. Reinsert pad under the disc housing, align with teeth and reinstall disc.
Good luck!
I would like to purchase this machine to clean my kitchen.
Why Leaking Compartment at right side next to pedal transport .
Maintenance adjustment ?
Hmmm, not sure. Sounds like a solenoid may have debris in it.
I own the same machine, but there is a problem that it does not drain water. Why?
Something is blocking the water solenoid. Clean and flush and try again.
Runtime on full charge?
Up to 8 hours based on using AGM batteries and if fully charged.
Will
This work on a textured floor?
Yes
The detergent has no time to do it's job this way. First wet the floor without hoovering. Wait a few minutes, so the chemicals can work. Then clean of with hoover on. After that you should neutralise the floor. Source: Kärcher dude.
That would really depend on the chemical being used and the temperature of the water. Also, the level of soil you are trying to remove. Good points!
How to change the pad
There are instructions in the manual. There is a level to drop them and reinstall.
How to do if the water not come out?
You may have a clogged solenoid screen. Lower Right hand side there is a rubber flap. Open the flap and unscrew the small grey cover and underneath is the screen. If you have a full tank use your water control valve to manage water volume when opened
@@billkrokoship thanks you 🥰🥰🥰
@@noeurnyanincambo810 You very welcome!
i have same this machain but can not drin watar
See if it is plugged.
Any factory warranty on this purchased new? Debating between this and a T5
How do u put on the scrub
Align it over the spline below and drop the right lift bar
hey how much does this cost.is it good for commercial
cleaning
Sells for $2995 plus shipping. Yes we have them in commercial applications.
Where is it made?
Germany
@@billkrokoship Any chance it will be made in china? How to know if the clean water is full in the tank?
@@cyranox90 well...many things are made in China. Who knows for sure.
Open the yellow cover on the front like in the video. There is a full line ...the flat area.
How do u put on the Scrubber
Center it and lower head on down on the gears
It would be more ideal to have a drainage area to drain that
Yeah, could have taken it to our wash sink. It did give you the reality of what we sucked up.
Drain the dirty tank first.
Although that is good to...we were making a video.....we don't have a slop sink.😢