Nice video, I think this will be my next project for my WJ. I was adjusting the steering wheel today by turning the rod and I noticed it has a lot of play in it, the whole bar swings forward quite a bit.
You did not show the ONLY part people needed to see....breaking the tie rod end free from the pitman arm. Yeah. THAT is the hard part. So of course you totally edited it out. Thanks.
You went all the way around the block when you could've just cut across the yard and you spent more money and bought more parts than you had to your definitely no mechanic smh and you obviously rode the short bus to school 🙄
Would you mind steering me in the right direction? I took my tie rod bar off and placed it next to my new assembly to get the measurements as close as possible. I noticed that the old one has a tilted tie rod end. Do I match that tilt angle on the new one to get the same measurement? Thanks!
Well done. I didn’t think to change the actual drag link. My tie rods are rusted
Nice video, I think this will be my next project for my WJ. I was adjusting the steering wheel today by turning the rod and I noticed it has a lot of play in it, the whole bar swings forward quite a bit.
Good luck!
Good video, man.
What size pickle fork did you use?
I had three in a kit. It's was the medium one. Just enough to split but not cut it.
Great video
Thanks!
wow That is helpful hints
Thank you.
You did not show the ONLY part people needed to see....breaking the tie rod end free from the pitman arm. Yeah. THAT is the hard part. So of course you totally edited it out. Thanks.
You went all the way around the block when you could've just cut across the yard and you spent more money and bought more parts than you had to your definitely no mechanic smh and you obviously rode the short bus to school 🙄
Would you mind steering me in the right direction? I took my tie rod bar off and placed it next to my new assembly to get the measurements as close as possible. I noticed that the old one has a tilted tie rod end. Do I match that tilt angle on the new one to get the same measurement?
Thanks!