Nissan Sentra 2007 to 2012 Intake tube replacement
Вставка
- Опубліковано 7 вер 2024
- This is how the intake rubber tube is replaced. It's become common for these to split causing running issues and Service Engine Soon light to come on. This video shows how it's replaced.
4 years old vid and still helping. I bought a commuter car (2011 sentra) and the check engine light came on a few days after i bought it, P0101 code when i scanned it. hole in the tube, can't believe i missed it before i purchased, but $35 wasn't a bad fix. I can manage most DIY jobs but your video sure saved a ton of before/after pictures and trail and error to get the end result. - Thanks man.
Glad it help! Thanks for watching!
Can you tell me where I should get this part from? After watching your video, I believe I can do this myself. But I want to make sure that I’m getting the correct part. I can see a lot that look right, but prices range from $20-$85!? If possible, direct me? Thank you!!
Excellent! Went to the dealer for a schedule PM. He showed me that mine was cracked at the very same place. The recommendation was to replace and Nissan would do it for get this...…$365. LOL. I googled the part and found it on Amazon for $40 and this video. 10 minutes later, BAM. DONE! Final results.....Part = $40, video instruction = FREE, peace of mind=Priceless Thanks again.
You did the right thing all way do research first. Because maybe you can fix the problem yourself.
Thank you for this simple and straightforward video. I saved $250 and it only took me like 30 min. To do it on my own 👍🏽
You are very welcome. Thanks for watching!
THANK YOU, my brother!!!! Im replacing mine and it literally cracked in the same spot!! Looked fairly easy to install but wanted to make sure i did it right
Your very welcome.. Glad this video helped! Thanks for watching
@@FixyourNissan is there any programming involved once installed? I know it's connected to the throttle body and that needs to be programmed once replaced.
@@michaelaizen1137 No programming required. Just put the intake hose on. If you clean the throttle chamber, use MAF sensor cleaner. But then a Idle Relearn would need be done, which is like programming so the computer can control base idle
@@FixyourNissan Thank you very much.
Thank you. This video was super helpful. The macaroni shaped piece of the intake had come off somehow and my car was stalling. I got the part and replaced it myself, saving me at least $100 if not way more.
Glad my video helped, and thank you for watching
Thanks for this video! My 2011 Sentra would hesitate badly in reverse and if reversing up even a small incline it would nearly stall. Found my tube is cracked! Wrapped duct tape temporarily and will go get a replacement part ASAP!
Thank you 🙏🏾🙏🏾 God bless my brother, straight to the point and simple
The dealership was going to charge me $100 for the labor to do this! Thank you for making this video.
You are very welcome. Thanks for watching!
Thanks dude.. I had a check engine light...and I do not know shit about cars but started realizing mechanics were ripping me off for shit I can do myself....replaced this part no problem with the help from your video
Glad my video was able to help you! Thanks for watching!
Thanks!! You just solve the problem to my wife's car. She was complaining about the stalling. I'm going to order this today.
Your welcome! Thanks for watching!
Thanks for the video! It fixed my car engine stalling at stops problem.
Glad my video helped ! Thanks for watching!
How big was Gap?
Did wife have to give the car some gas.
Thanks for mentioning the “trans vent tube” as I thought it was a vacuum tube that had come off on mine.
Allot of people think that! Thanks for watching
Wow that does look easy enough to do. I want to learn and get a hands on feel for my car. Thank you for the great info
You're Welcome, Thanks for watching!
Great video....replacing it today; you made it look so easy!!!
Thank you. Glad my video helped you!
Great Video i had the same problem i got a P0101 i thought i needed a MAF turns out it was the hose was cracked and it caused me to get a AF sensor code po131 got it fixed nicely
You're Welcome. Thanks for watching!
After you installed, how long did it take for your car to ride normal?
@@marquesjacobs6109 This was back in the winter so maybe a day or two
@@marquesjacobs6109 After you clear the codes, it should return back to normal operation
Mine had a idle and reverse problem. Had the same hole. Thank you for your help
i felt like such a handy man, thank you for this!
You are very welcome! Glad I could be helpful for you!
Jay, thanks for the clear instruction and the well shot video!
Super straightforward and helpful!! Thank you very much!! 👍🏻
You are very welcome. Thanks for watching
Excellent thank you so much!!!! Was the exact problem I had.
You're Welcome, and thank you for watching!
Sweet, that was crazy fast and helpful! Thanks
You are very welcome. Thanks for watching
Thanks dude you’re a lifesaver!
You're Welcome, and thank you for watching!
Thanks for the assist with the video!
Thank you! Just saved me $250👌
You are very welcome. Thank you for watching.
I have pulled my trans vent tube out of its location and don’t know where to put it back. Can someone please help
prick mechanic wants to charge me 200$ to replace this thing. thanks for the video!
Just what I need to replace my Nissan 2009, same issue. Thanks.
You are very welcome. Thank you for watching!
Just did it today...thanks
You are very welcome. Thanks for watching!
Good video and clearly also.
Thank you for the kind words and thank you for watching!
@@FixyourNissan video helped me out, I did the same work yesterday and the video helped me how to change it right.
Question, if you pause at 0:14, what is that hose in the center, lower part of the screen with the white lettering, attached by the plastic clip, to the left of the reservoir? What is it called, and what is its purpose? Thanks!
Very helpful
Do you have a video on this for a 2000 Nissan Sentra? There's a special bracket that I don't have a clue about how it comes apart and I'm afraid of breaking it, it's located on the the side and holds two vacuum hoses
Good evening Jay. Thank you for this is was awesome. Listen, do you have a video on how to replace the intake manifold gasket on a 2007 Nissan Sentra. Please any suggestions. Thank you. Have a great night
My wife has a 2012 sentra sl...the service engine light is on po171 code bank 1...and the intake tube has a big cut in it...I ordered it online for about 25 bucks..my question is once I put it on will the light go out or will it need to be cleared?
Thank you for watching my video. Glad you found the video helpful and you found your issue. As for your code. You will need to clear the light after you replace the air intake duct. To clear it, just disconnect the negative battery cable for 15 mins. That will clear the light.
@@FixyourNissan Cool Thanks for getting back to me bro!
I have an 07 Sentra and it has the same piece that's cracked in the same spot but doesn't completely stall. However it does shutter when going at higher speeds or when accelerating. Could this also cause those symptoms? We've had the tires changed, suspension checked, bearings replaced and it still shimmy's and shakes.
If it's cracked in the same area, it's allowing un-metered air to enter which can cause the car to shutter, bog, or Stall. So if it's cracked, like this one. The part is cheap. Replace it and see how it is after!
@@FixyourNissan well we replaced it, still doing the same thing. Too it to a mechanic and he said it's the CV Axel's and the shocks we're installed incorrectly by the last mechanic.
What causes the candycane looking thing to come out, I've lost 2 and had to buy the whole pt
There is just a clip part that the transmission vent line attaches to
Out of curiosity, was that causing a misfire issue for you ?
Does his affect Rpm went driving?
Yes actually. The engine doesn't get enough air because of the cracks in the hose. So the engine has to work harder (higher rpm) and fuel more to compensate for that loss in air therefore affecting rpm.
Good stuff, thx
Will a ripped air intake boot turn a service engine light on?
It can.
Thank you
Just wondering that the big plastic box on the tube is for? I recently replaced my tube with a cheap one and now seem to be having issues with oil consumption. Could this be an issue?
The Tube in this video is the Air intake tube. Changing this will not cause an oil consumption
@@FixyourNissan yes, but that box on the tube is hooked up to some sort of breather hose on the engine. I'd like to know why, as there is another hose for the pcv valve
@@KenyonPayne That hose is a vent hose for the transmission
Hey thanks for the video. What do you called that power tool you used? And what size? Thank you
That is a Electric 3/8 impact gun
@@FixyourNissan if you dont have that, what else can you use?
Screw Driver to loosen the intake tube clamps
Has anyone got a part number for this hose thanks
What the brand u put in
Will I my check engine light still be on after I do this repair? The guys at the parts shop said to disconnect the battery prior to the installation and it should not come on after the new part was is in place.
The codes would need to be cleared with a scanner, or if you disconnect the negative battery cable for 15 mins to clear the codes. The warning lights will not go off on their own.
Can this part cause a P0101 code to light up? Ive been having a P0101 code for quite some time. I even bought a OEM MAF sensor and the code still persists
It could cause it may think the MAF sensor is not metering air properly. If you replace the Air intake tube and still get this code after you clear it. Then you need a MAF sensor. Do not get a After Market one!! They never work right!
@@FixyourNissan How much is a air intake hose?
@@juice323blue4 It's like 40 bucks or so
@@FixyourNissan will putting duct tape over the hole work.
@@juice323blue4 40 bucks
What is the purpose of that hooked boot/clamp piece thats attached on top? Do they sell that separate? That's what has fallen off of mine.
If you look at the new Boot I installed. It comes with that piece. The part is not that expensive. I think it's like 60 bucks or less.
Where you getting any check engine light codes?
You would need a scanner to link to the car to read Fault codes. You would only need a scanner if you have a Fault Warning light. Such as a Check Engine Light
Idle re-learn afterwards?
Hello, i changed the air intake duct, it doesnt power off now, but Still stalling at stop, so i need to purge air in some part? Thanks
Thanks for watching. You may want to check the air intake tube and make sure it's not folded on the bottom causing a vacuum leak.. That can cause what your describing.
FixyourNissan Is it ok to just replace the hose only and reuse the other bits from the original?
@@FixyourNissan can spark plugs cause the same problem?
Whats the part really called? I can't find it anywhere
Or air cleaner intake hose
Air intake hose is what it’s called when I search it up
Tyr Ebay! I found one for 20 bucks brand new. I just call it Air Intake Hose
How do you get to stop folding when you try and get it in
It’s all in the wiggle
What's the hooked piece hose clamped to the top called.
That is the transmission vent line.
The upper duct tube your thumb is on at 1:33. What does it do?
Awesome thank you
Hey man what kind of symptoms did you get from that issue? I'm going to check mines it's the same model, I'm not sure if I have a leak
Bogging on acceleration, lack of power, Service Engine Soon light, Stalling.
Also horrible gas mileage...just found out this was what was causing my problems...thanks for the vid.
Your welcome and Thank you for Watching!
@@FixyourNissan did you have given the car gas to warm up the engine.
Where can I buy the piece? grcias
Gonzalo Duran Amazon
does this problem causes the car to stall at stop?, i have a 2010 sentra that stall at stop.
thanks bro, appreciate your effort in giving me info.
Abe yes. I recently got an air fuel ratio sensor put in. But then a month in a half later is started stalling, and jerking when I put too much on the acceleration too fast. And told me it was an air intake hose. They were charging out the ass and back in again to fix it. I could do this, but they also said it needed to be cleaned so for me it might not just be as simple as buying it for 40 and putting a new one on
check if the hose, the one after the filter is cracked, if it is buy new one an install it yourself. you will save some extra money by doing so. that happens to my car and it did fix the stalling problem..
Getting my checked this week. My car is doing the exact same thing.
Does this cause engine light to come on
It could
@@FixyourNissan is best to clean it first before replacing it
@@juice323blue4 You can certainly use MAF sensor cleaner and clean it. It won't hurt anything.
Just do not clean the Throttle chamber. If you clean that, you will have to do a Idle Relearn
What if it still do it
The of course the issue is something else, and may require more advanced diagnostics to determine
You wouldn’t know another reason why it keep stalling like that
@@corderboy297 There is many things that can cause stalling. Bad Electronic Throttle chamber, Cam or Crank Sensor, MAF sensor, Bad Fuel pump. Those are just some of the most common. But since there is so many things, that is why checks need to be done.
Well it don’t stall anymore since I changed the intake it’s not going over 3000 rpm still would that be a fuel jump problem?
@@corderboy297 It would require diagnostics to determine why it's doing that still
What was the price
Joe Blackwell it is bout 16.00 on Amazon
What is the curve piece on top of the intake tube called
The air intake duct?