To be honest, they both look off center (noticeably), and I'm dealing with the same issue and can't find anything that solves it. I engrave and cut in the same job but the cut is always off center of the engraving, no matter what order I do them in. Makes no sense... I too am using a circle cut pattern, I wonder if that's where the issue is...
I can't seem to find the specific size basswood that came with the machine (290mm x 420mm/16.54" x 11.54"). The closest I can find is 12" x 18". Will this be close enough to run the calibration or does it have to be that specific size?
@@HkeCheermom you will need to adjust them if they are not lined up. The wecreat UA-cam channel has that in their video. As mine lined up perfectly I did not mess with that portion of the alignment
To be honest, they both look off center (noticeably), and I'm dealing with the same issue and can't find anything that solves it. I engrave and cut in the same job but the cut is always off center of the engraving, no matter what order I do them in. Makes no sense... I too am using a circle cut pattern, I wonder if that's where the issue is...
I can't seem to find the specific size basswood that came with the machine (290mm x 420mm/16.54" x 11.54"). The closest I can find is 12" x 18". Will this be close enough to run the calibration or does it have to be that specific size?
That I don’t know.
are you sure it is the screw holes on the top of the gantry or the one on the side where the divot lines up with a hole on the side of the gantry?
I’m sure it’s the top
I also have the two screw holes but they do not line up...
@@HkeCheermom you will need to adjust them if they are not lined up. The wecreat UA-cam channel has that in their video. As mine lined up perfectly I did not mess with that portion of the alignment
What you didn’t include is what to do if the holes don’t line up.
@@laokiriazis7 go watch the wecreat video for that cause mine did and I wasn’t messing up a good thing
I put a piece of paper over the already used basswood it works that way
Thank you for the tips!