Land Rover P2463 P2ABE P2ABF DPF LIMP MODE FIXED

[@inbloomgardens]

You don't happen to close to OL4 area?? Having this fault on my car at the moment

[@jezbooth3505]

good job.very clear and intuitive

[@sadiagnostics]

Thank you

[@jezbooth3505]

@@sadiagnostics where r u based

[@sadiagnostics]

@@jezbooth3505 sorry I don’t do diagnostics any more. Thanks

[@garrieparsons2265]

i thought you had to flush cleaner threw dpf filter to clean it out to resolve the problem //not just clear the code with a scanner that anyone could do ...with a cheap obc scanner ...please reply

[@sadiagnostics]

No incorrect, you can add the fluid before you get this fault but once you do you have to use a reasonable diagnostic machine cause not all cheap machines will do this job I promise you. Once you have this fault in stored in the ECU you will not be able to delete it without a diagnostic machine…. You can also check and confirm with dealer or other garages too.

[@garrieparsons2265]

@@sadiagnostics so your just deleting the code not solving the problem ok .. thanks for explaining 👍

[@sadiagnostics]

@@garrieparsons2265 no I don’t think you listened or watched the video. You have to do a motorway regen and keep the speed above a specific mph/kph. Then you can reset the sensors. Please watch the video to know what it’s about rather than just watching a few seconds of it. Thanks

[@bendelbridge]

Pretty sure he said he took it for a run as recommended by the scan tool. I just don’t think he published the actual driving of the car part in the video.
Codes were only cleared after this was done to make sure they didn’t return

[@davidwaters5348]

Hi do you have to tell the car it's had a new pressure sensor fitted ?

[@sadiagnostics]

Hi yes

[@davidwaters5348]

@@sadiagnostics thanks

[@AhmedAli-hu8ng]

Thanku boss great job

[@sadiagnostics]

Thanks