Can you do a fuel filler service.. as I can't find mine on my 450 racing mercury.. a have a water separate filler in the aft of the boat. But I can't find a fuel filler on the engine..
Yes, you’re absolutely right, as I’m checking the video over, I noticed the part replacing the filter was not uploaded. Thank you for bringing it to my attention. If you look inside the engine lower cover on the starboard side aft corner, you will see the filter element. Just disconnect the wired connector first, then disconnect the two hoses by pushing in the red tabs and then pull, then to remove element turn clockwise, once removed you’ll be able to see how is fastened to the engine, then installed by turning clockwise, re-install hoses by just pushing in until it clicks. Re connect sensor plug. turn to the on position (DONOT RUN MOTOR) and let the pump runoff 5 seconds. I do this twice. Then you’re good go. Keep in mind on some 2022 models that filter is no longer there, and now is installed inside the boat. Thanks again, I will make a video of it right away, hope you don’t mind if I mention you.
Great information, Do you have a video of the alternator belt replacement and the supercharger pulley replacement?
I thought this video shows replacing the belt? No don’t have one replacing the pulley as of now. Thank you for watching. Take care 👍🏻
Bien importante son los típs, que menciona, en que parte de USA , está ubicado ??
Hola Roberto, gracias por tus comentarios, estoy en el area de Fort Lauderdale. Creo que ya Mañana sale la segunda parte. Gracias
@@us4marine Where in Fort Lauderdale? Very good work. Very thorough.
Can you do a fuel filler service.. as I can't find mine on my 450 racing mercury.. a have a water separate filler in the aft of the boat. But I can't find a fuel filler on the engine..
Yes, you’re absolutely right, as I’m checking the video over, I noticed the part replacing the filter was not uploaded. Thank you for bringing it to my attention. If you look inside the engine lower cover on the starboard side aft corner, you will see the filter element. Just disconnect the wired connector first, then disconnect the two hoses by pushing in the red tabs and then pull, then to remove element turn clockwise, once removed you’ll be able to see how is fastened to the engine, then installed by turning clockwise, re-install hoses by just pushing in until it clicks. Re connect sensor plug. turn to the on position (DONOT RUN MOTOR) and let the pump runoff 5 seconds. I do this twice. Then you’re good go. Keep in mind on some 2022 models that filter is no longer there, and now is installed inside the boat.
Thanks again, I will make a video of it right away, hope you don’t mind if I mention you.
@US-4 Marine Thank you so much for your help it's much appreciated..