2020 Ram 1500 Big Horn LED install!! Lasfit Lighting!
Вставка
- Опубліковано 19 лис 2020
- Full Halogen to LED lights using Lasfit High beam, Low beam, and fog lights!! Truck is a 2020 Ram 1500 Big Horn! Insane before and after and DEFINITELY worth it!
Interested? Use my Lasfit link for 10% off all products!
lddy.no/rac1 and use code ChrisD10!!!!
Huge thanks to Lasfit!!!!
The camera angles are so on point. Extremely informative and instructed.
Any issues with canbus going off or DRL not working? Any flickering? I just got a 23 Ram 1500 Big Horn and hate the halogens
How did you put the seal cap back on over the ballast without putting a hold in the seal ?
I didn't have any issues, went on just fine and so far has maintained waterproof. No condensation
@@ChrisDusek so you didn’t put a hole in the rubber cap?
@@staythecourse7915 I didn't have to, everything fits under the dust cover
Which direction should the tips of the bulbs on the high beams and fog lights be facing, directly vertical (12 and 6 o’clock)? I looked through the lenses on mine and they’re kinda diagonal but I can adjust them
I had mine exactly positioned at 12 and 6.
Thanks
@Christopher D, Any issues with the radio signal and the Lasfit bulbs?
Absolutely zero issues so far, I've read somewhere that happened to someone but luckily for me nothing to complain about.
I just installed these too. Anyone flashing their brights at you? Did you adjust the headlights down any and did you line all the led chips up to 9 and 3 o' clock ?
I have the same issue these are bright and might be TOO bright but not sure how to adjust this 🤔
I frequently get flashed, but I think either way it's going to happen with aftermarket LED bulbs. I haven't adjusted them down yet. I will adjust them down once I install the lift I want.
@@ChrisDusek how do you adjust them down?
@@christiangomez2093 there are 2 hex screws on either side of the engine bay. I bet you could find some pictures or video on youtube.
@@ChrisDusek okay thank yoy I'll look it up.
How they holding up??
Yea…I was wondering too
Any issues with hyper flashing or needing resistors? Do the drivers fit behind the housing cap just fine?
I've had zero issues, no resistors needed, no hyper flashing of any kind. Also, they fit great behind the caps! Highly recommend the headlights and I'm not getting paid to say that LOL!
Lol with the magic of tv there you go it’s in...come on I replace mine and really the easiest way is taking the whole headlight assembly out lol this guy he’s funny..
It was easy enough to do where you don't have to remove the whole headlight assembly..
Lol trust me I’m pretty Mechanically inclined and changing a bulb with one hand in a confined space not so simple. I took apart the front end and found it to be yeah a little time consuming but less frustrating.. and also the passenger side had to adjust the buld clock position so now we’re talking taking the bulb out a few times so people take the front off it’s more practical
Definitely not simple, but easier than removing the actual headlight assembly is for sure. Luckily I have smaller hands so it wasn't to much of a pain to get it done. Tight squeeze definitely.
I just did mine in a 21. No need to remove head light. Any idiot can do this and I’m NOT mechanically inclined
@@Briguy933well I guess your special 😂
Do you get condensation in your headlamps?
Zero issues with headlights, the fog lights I've seen condensation one time but it was pretty cold outside.
What’s led lights did you use & fogs ??
I used Lasfits Switchback LEDs. So turning them off and on would cycle them from yellow/amber to white. Great lights.