Malcolm, No problems, Mini Max came over to see me last night and has passed on some good tips to me which i will pass on to you guys, I love it when you get a tip that makes absolute sense but never thought about it! Cheers Dave.
hi dave, i would have liked you to fit a new ball joint into a cleaned housing as this is a hard job for novices to understand reading the manual eg the measuring part of the job also some people use a fishing scales after doing the job to check the tightness of the movement of the joint. thanks dolores
Dolores, OK i can do a second set from the black Mini which i will show the whole job but there are many videos on this subject on youtube, Let me know again if you want to see a video from start to finish. Cheers Dave.
hi dave i would like to see you do the job from a to z ,i could only find one vid on subject, it was where an older man reused the worn ball joints and after it had tight spots in its full movement range when put back together. the mini has quite a few hard to under stand jobs when reading the manual ,some of the others are shims, thrusts on engines roller and solid bearings on rear shaft and others.also most owners have had no engineering type jobs and so terms etc are new to them unlike their fathers. thanks dolores
Thanks Dave for another highly informative video. Cheers Malcolm
Malcolm, No problems, Mini Max came over to see me last night and has passed on some good tips to me which i will pass on to you guys, I love it when you get a tip that makes absolute sense but never thought about it! Cheers Dave.
Good info. I never knew they come apart like that.
Dave, I just saw this. You might get a few ideas for your caravan project.
www.instructables.com/id/Build-a-Custom-Camper-Gypsy-Wagon/?
Good descriptive video. I am not too far away from that job myself
I will finish it off tomorrow as the camera went off again. Cheers Dave.
Good job Dave, thanks for that video!
Sean, Thanks mate, Bit basic info but i hope it helps someone who has not done it before. Cheers Dave.
Great vid Dave
Cheers
Jamie
Jamie, Thanks but like any job if your doing it the first time it gives you a heads up. Cheers Dave.
hi dave, i would have liked you to fit a new ball joint into a cleaned housing as this is a hard job for novices to understand reading the manual eg the measuring part of the job also some people use a fishing scales after doing the job to check the tightness of the movement of the joint. thanks dolores
Dolores, OK i can do a second set from the black Mini which i will show the whole job but there are many videos on this subject on youtube, Let me know again if you want to see a video from start to finish. Cheers Dave.
hi dave i would like to see you do the job from a to z ,i could only find one vid on subject, it was where an older man reused the worn ball joints and after it had tight spots in its full movement range when put back together. the mini has quite a few hard to under stand jobs when reading the manual ,some of the others are shims, thrusts on engines roller and solid bearings on rear shaft and others.also most owners have had no engineering type jobs and so terms etc are new to them unlike their fathers. thanks dolores