Hello Shane Welcher, I need to set up a DEMO KIT to test Motor and Driver AB, do I need to use a PLC? Can the Kineix 5000/6000 be connected directly to a PC via Studio and Test RUN like this video?
Hi sir, I want some information if you give I am very thankful to you. My question is... I have a servo unit pack. here we one power supply, one kinetix 5700(S130) ,two kinetix (D057) these are add in motion group in studio 5000. Here we easily change MRP parameter through Motion direct command. and two kinetix 5100 servo drive add ungrouped motion group in studio 5000. Here we can't change MRP parameter. So my question is How to change MRP parameter ungrouped motion network.
If the servo is ungrouped then it is uncontrolled therefore you are unable to change the position using an MRP instruction. The only servos that can be changed are in active motion groups. I would also use a home instead of an MRP unless the logic demands it because if the power is lost to the servo, it will default the position to the last homed position. I hope this helps, Shane
Subscribe: ua-cam.com/channels/3B7gA1HAcbuPZOkBklFwuA.html
Other socials:
Facebook: facebook.com/OnlinePLCSupport
LinkedIn: www.linkedin.com/in/shane-welcher-sr/
Thanks you are a great teacher..
You are welcome!
You’re videos are great, Shane.
Thank you
THANKS ...max informative ...
Glad I could help
Boa noite! Ótimas informações! Obrigado!
Thank you
Hello Shane Welcher,
I need to set up a DEMO KIT to test Motor and Driver AB, do I need to use a PLC?
Can the Kineix 5000/6000 be connected directly to a PC via Studio and Test RUN like this video?
No
What would the process look like if the servo had an internal brake?
The same, just not for external brakes
How to control PowerFle Drive in Torgue control ?
That's not easy to explain via text.
It depends on the drive used plus how its being implemented
Hi sir,
I want some information if you give I am very thankful to you.
My question is...
I have a servo unit pack. here we one power supply, one kinetix 5700(S130) ,two kinetix (D057) these are add in motion group in studio 5000. Here we easily change MRP parameter through Motion direct command. and two kinetix 5100 servo drive add ungrouped motion group in studio 5000. Here we can't change MRP parameter.
So my question is How to change MRP parameter ungrouped motion network.
If the servo is ungrouped then it is uncontrolled therefore you are unable to change the position using an MRP instruction.
The only servos that can be changed are in active motion groups.
I would also use a home instead of an MRP unless the logic demands it because if the power is lost to the servo, it will default the position to the last homed position.
I hope this helps,
Shane