Commission Kinetix 350 Servo Drive Allen Bradley L18

[@fabianhernandezramos2952]

thanks for your time, l learn so much with this type of video

[@e.j.daigle2558]

Great video! We have 24 of these drives. I use this video to remind myself of how to set up.

[@123jordanford321]

Useful video thanks. Happened to have the L18 processor and a Kinetix 350 so this was really ideal!

[@vorapobautomation9760]

HOW to setting and programming SLAT function with kinetix 5500 ?

[@chuongnguyen3604]

I used the Rslogix 5000 but I might find the kinetix 300. I can upgrade the new version now ?

[@fethilakhdari1078]

Good video, too bad the video resolution is so poor, that it takes so much quality away from your good work

[@FC-hr9he]

How is this wired? can you show the wiring in a video?

[@SonNguyen-hq6vi]

how to software ??

[@jorgedominguez335]

Hello, I followed all your steps and I was able to configure the Kinetix and the servo with no problems. The only problem I'm having is when I unplugged the ethernet cable from the kinetix drive my PLC (L61) goes to Fault Mode, Any suggestions what is happening?

[@luissalazaringresosintelig1493]

Prueba esto:
Module Properties (kinetix)...
Pestaña Connection...
Major Fault On Controller if Connection FAils ( no debe estar seleccionado)