Thanks for watching everyone. We only have a couple more videos to go for this TT-02B kit. What will I build next? I will reveal the next build in the coming days. 👍
I love your heat shrinking of the receiver and antenna wires. It cleans up your chassis so much. Looks very clean. Im going to implement these ideas into my new M07R, M08, wpl c24, c34, and summit.
Nice to see your videos again. As a TT-02B Plasma Edge II owner I have 2 suggestions I hope you accept/appreciate: make sure the body sits well with that ESC on top of the servo, there isn't much space there. Also the body on the sides is very close to the chassis, not sure if those wires on the side will allow the body to sit well.
I just finished putting on the wheels and body posts. I think you're right. The ESC/Motor wires are definitely interfering with the body sitting properly. I will address it in the decal video. Thanks for the heads up. 👍
** Please show how you made the receiver box fit between the motor and servo without damaging the motor wires. It's the one section that's giving me the most grey hairs! **
Thanks for watching everyone. We only have a couple more videos to go for this TT-02B kit. What will I build next? I will reveal the next build in the coming days. 👍
I love your heat shrinking of the receiver and antenna wires. It cleans up your chassis so much. Looks very clean. Im going to implement these ideas into my new M07R, M08, wpl c24, c34, and summit.
Thanks 👍
Nice to see your videos again.
As a TT-02B Plasma Edge II owner I have 2 suggestions I hope you accept/appreciate: make sure the body sits well with that ESC on top of the servo, there isn't much space there. Also the body on the sides is very close to the chassis, not sure if those wires on the side will allow the body to sit well.
I just finished putting on the wheels and body posts. I think you're right. The ESC/Motor wires are definitely interfering with the body sitting properly. I will address it in the decal video. Thanks for the heads up. 👍
Thanks for sharing. 🙂☝
Thanks for watching!
** Please show how you made the receiver box fit between the motor and servo without damaging the motor wires. It's the one section that's giving me the most grey hairs! **
I bent both motor terminals towards the starboard side of the car and pushed the wires with the receiver box.
@@RCsRCCars Wow. How did you know that would not break the motor wires?
Just wanted to know where to plug the wires in. Everything up to the point you didn't mention any of it was pure idiocy.