Hi I have a valve spring compressor and my intake valves came out with it but when I tried the exhaust the spring won't compress I feel I'm going to break something, do you think I mallet method will work?
Ball up a rag and place it in the combustion chamber of the head on a flat surface and then use a Hammer or Rubber Mallet with a 17mm Socket, place the socket over the valve spring and firmly hold down and smack the socket with a hammer a couple time the keepers should pop loose. Hope that helps!
Yes you have to. The new valves come with a perfect 45° angle on the bell and the seat needs to have that perfect match to make a seal and so they don't wear prematurely.
It allows me to Blend the Aluminum and Guide into each other which allows air to flow over that area much smoother. Check out my newest video you'll see what I am talking about.
Believe me, I am not going to re use the valves. At least not the intake valves I am replacing with Fearra's. That's also why I balled up a rag or and put it between the combustion chamber and the bench when you do this, I might have left that part out.
Finally a good porting video. Well done!
I will have more in the Future. Thank you for watching!
Hi I have a valve spring compressor and my intake valves came out with it but when I tried the exhaust the spring won't compress I feel I'm going to break something, do you think I mallet method will work?
Ball up a rag and place it in the combustion chamber of the head on a flat surface and then use a Hammer or Rubber Mallet with a 17mm Socket, place the socket over the valve spring and firmly hold down and smack the socket with a hammer a couple time the keepers should pop loose. Hope that helps!
@@trxtech3010 thanks will try this later
Do you cut the seats when you install new valves ?
Yes you have to. The new valves come with a perfect 45° angle on the bell and the seat needs to have that perfect match to make a seal and so they don't wear prematurely.
@@trxtech3010 alright thanks for the info
Why do you drill down the guide, what does the guide do
It allows me to Blend the Aluminum and Guide into each other which allows air to flow over that area much smoother. Check out my newest video you'll see what I am talking about.
I have a Question
yes?
@trxtech3010
What does cutting those valve seats off do I have a trx 450 2006
If you plan on re using the valves I would avoid the mallet method, I learned the hard way that It can bend valves lol
Believe me, I am not going to re use the valves. At least not the intake valves I am replacing with Fearra's. That's also why I balled up a rag or and put it between the combustion chamber and the bench when you do this, I might have left that part out.
Рассухариваешь интересным способом)