Thanks I have a plastic line on my vette now and it keeps leaking on the engine side where it screws in the block I tried everything I could to stop it pipe dope and teflon tape and it still seeps out i hope this kit takes care of it thanks again 😊
The way the copper line comes out of the engine against the tach cable worries me a little. Is it possible to put an elbow there so the copper doesn't have to make such a hard bend coming out of the fitting?
Thanks I have a plastic line on my vette now and it keeps leaking on the engine side where it screws in the block I tried everything I could to stop it pipe dope and teflon tape and it still seeps out i hope this kit takes care of it thanks again 😊
Man I have a huge leaking all over the floor replace it ASAP!
Maybe a short piece of 1/8 rubber hose, split it and use it in the clamp. All good, nice job on this project!
Yeah - I was thinking the same - no metal on metal.
Another step closer. Good job. Good insurance.
Hi can you tell me where you bought that oil line I like the way it is brazed on thanks Steve
Sure : amzn.to/3QcQtpr
The way the copper line comes out of the engine against the tach cable worries me a little. Is it possible to put an elbow there so the copper doesn't have to make such a hard bend coming out of the fitting?
I don’t like that aspect either. Seems like a poor design choice. I can look for a 90* fitting. I don’t think it will be an issue, however.
Did it come assembled? With the fittings and solder? Ready to install?
@@SyracuseIsOranges Yes
Copper work hardens, and engines move.