I performed this upgrade, however my printer is not properly utilzing the Z Offset. I perform the leveling, it goes to the center and I adjust the Z Offset (to barely allow the paper to pass between the printhead and the heatbed. I then load a test print and it is obvious the Z Offset adjustment is NOT applied as the printhead is scratching the heatbed. Any ideas?
Hello! It seems like there might be a discrepancy in the Z Offset adjustment. To address this, manually adding up to 0.2mm to the current offset. This should bring the nozzle up to the correct level. Sometimes, issues like this can arise as the Z Offset distance matures or changes over time. Give this adjustment a try, and it should help prevent the printhead from scratching the heatbed during your prints. If the problem persists, consider recalibrating or checking for any other factors that might be affecting the Z Offset. Hope this helps!
Did you find a solution, I have the same problem but in the opposite direction, mine doesn't touch the bed on the first layer and just slightly hovers above the bed. Seems like some sort of bug, I am planning to re flash the firmware I just need an SD card
I performed this upgrade, however my printer is not properly utilzing the Z Offset. I perform the leveling, it goes to the center and I adjust the Z Offset (to barely allow the paper to pass between the printhead and the heatbed. I then load a test print and it is obvious the Z Offset adjustment is NOT applied as the printhead is scratching the heatbed. Any ideas?
Hello! It seems like there might be a discrepancy in the Z Offset adjustment. To address this, manually adding up to 0.2mm to the current offset. This should bring the nozzle up to the correct level. Sometimes, issues like this can arise as the Z Offset distance matures or changes over time. Give this adjustment a try, and it should help prevent the printhead from scratching the heatbed during your prints. If the problem persists, consider recalibrating or checking for any other factors that might be affecting the Z Offset. Hope this helps!
Did you find a solution, I have the same problem but in the opposite direction, mine doesn't touch the bed on the first layer and just slightly hovers above the bed.
Seems like some sort of bug, I am planning to re flash the firmware I just need an SD card