Is this a used cam? If so, you can measure the lobes to make sure they are still in tolerance. You simply find a good spot on the low spot on the cam with a set of calipers and zero it out then roll it around to the high lift area, do this on of four lobes and they should all be close to the same height. Did your cam come with lifters. If or if not I like to have stock lifters reground.
I have 1.25:1 rockers with a engle W100 cam. It seems to be a good combination. But I'm new at this 😀
Is this a used cam? If so, you can measure the lobes to make sure they are still in tolerance. You simply find a good spot on the low spot on the cam with a set of calipers and zero it out then roll it around to the high lift area, do this on of four lobes and they should all be close to the same height. Did your cam come with lifters. If or if not I like to have stock lifters reground.
Good job 👍