I’d knock that end plate off while it’s out and advance the timing a few degrees! No load on the motor set power supply at 4-5v tops! and advance till it’s screaming and done! Never do this with a higher power motor at full voltage if you like your fingers! Then install and run it on 3-4s and once it’s completely melted or exploded replace it with brushless lol! Nice break in btw!
Just stumbled upon your channel in the algorithm somehow. Liked and subscribed before I even watched this video, simply from the content and the fact that you are a fellow Aussie based RC enthusiast like myself. Gets repetitive listening to American/European RC Hobby channels 🙄
I’d knock that end plate off while it’s out and advance the timing a few degrees! No load on the motor set power supply at 4-5v tops! and advance till it’s screaming and done! Never do this with a higher power motor at full voltage if you like your fingers! Then install and run it on 3-4s and once it’s completely melted or exploded replace it with brushless lol! Nice break in btw!
Just stumbled upon your channel in the algorithm somehow.
Liked and subscribed before I even watched this video, simply from the content and the fact that you are a fellow Aussie based RC enthusiast like myself.
Gets repetitive listening to American/European RC Hobby channels 🙄
Cheers for the support.
What???