I needed to make a slightly more than 90 degree angle and I had to cut much more than 25mm. If you ok with a grinder or with a scissor cutter it is better to cut less as you can always cut more to adjust to reach an angle you want. In my case it has taken four times or cutting extra. If you overcut you just ruin a downpipe. I think a decision on how much to cut depends on a height of a pipe and an angle required. I think if the pipe is 80mm in height and you need to get a 90% angle you need to cut half of 80mm which is 40mm.
Roy needs to make more vids - AWESOME VID!
The high speed overview at the very start was perfect. Good to know what the video is about I probably could've made it off that alone.
Mate these videos are gold thank you very much
Thank you, well done, plain and simple.
Excellent use of angles and creativity!
Pure artistry wow perfect cut
just what i needed, cheers.
Very helpful. Thanks !!
How do you get the right angles? Some pipes may be different angles when they meet up
Brilliant!
Does this make a 45degrees?
Is there a vid on how to do this on a round down spout
Parabéns aqui no Brasil fazemos assim
Thanks 🙋♂️
We used a machine, I think it was called a miter biter. We soldered the joints. Galvanized.
How do you measure from the gutter to the wall?
Hi Silas, are talking about a gooseneck downpipe? We are in the process of editing the video, I will send you a message once we upload it.
Gooseneck downpipe video: ua-cam.com/video/UgxR4mRKucg/v-deo.html
What size rivets??
4-2 rivets, 3.2mm thick x 6.4mm long
Thank you
What are the measurements for the lines you drew?
Does 25mm from the line work for every size of downspout?
I needed to make a slightly more than 90 degree angle and I had to cut much more than 25mm. If you ok with a grinder or with a scissor cutter it is better to cut less as you can always cut more to adjust to reach an angle you want. In my case it has taken four times or cutting extra. If you overcut you just ruin a downpipe.
I think a decision on how much to cut depends on a height of a pipe and an angle required. I think if the pipe is 80mm in height and you need to get a 90% angle you need to cut half of 80mm which is 40mm.