Thank you for the comment and subscribing 😊. Had almost to travel to the orkney once. Was on a job on a well boat at shetland, and would have to sail to orkney if we didnt finish the job before they had to sail. Nothing against orkney island, but I get very easy sea sick 😂😂
Hey! Min XT350 ryger fra udstødningen og der er olie både på silencer og på venstre side af cylinderen. Kan det være pakningen bare? Eller også Valve Stem Oil Seals? tak!!
Hei! Går ut frå at du meiner eksosporten til sylinderen? Altså der eksosanlegget er festa til sylinderen? Dersom det er vanskeleg å få sett skikkelig, ville eg tatt av tanken. Då ser du toppen og sylinderen litt bedre. Eg trur kanskje du har ein lekkasje fra enten pakningen til toppdekselet eller pakningen på ein av toppdekselboltane. Lekkasje frå desse vil kunna renne ned på eksosanlegg og langs sylinderen som du seier at det gjer på din. Dersom du ikkje har sjekka ventilar på ei stund, ville eg samtidig ha bytta desse pakningane. 🙂
@@halvardollikainen3999 Thanks! I just bought new valve stem seals - are those the ones you refer to? I see the oil coming out on the side of the cylinder (not near the exhaust connection) and then at the very tip of the silencer in the rear back where it smokes like crazy. The exhaust does not seem to have any holes at least (the smoke it the perfect check for that :D )
If it was leaking from the top or between the top and the cylinder, I would consider replace cylinder cover gasket and seals for cylinder cover bolts. These are not the valve seals. But in your case, it sounds as it might be valve seals or leakage through piston rings? A leak down test og compression test will verify this. Is it running strong and starts easy? If the piston and cylinder have high mileage and are original, it might be time to inspect and consider servicing 🙂
@@halvardollikainen3999 uhh. yeah it has high mileage but it normally starts and runs perfectly. I have already bought the seals and the valve cover gasket so will replace these and see if that works! thanks so much!!
Takk for fin video! Du må gjerne lage flere om denne sykkelen. Godt lys og gode næropptak settes pris på🙂!
@@mattdrat3087 takk for fin tilbakemelding 😊. Kan godt vera at det kjem meir om den og 🙂
Thank you and good luck with your XT i have a 1991 im rebulding rn just exited whatching these bikes rip
Thank you and thanks for the comments 😊. I plan to make some content with the xt, both in use and working on it. So feel free to check another time 😊
@@halvardollikainen3999 awsome will do for sure
New Sub. From just over the pond in Orkney ✌
Thank you for the comment and subscribing 😊. Had almost to travel to the orkney once. Was on a job on a well boat at shetland, and would have to sail to orkney if we didnt finish the job before they had to sail. Nothing against orkney island, but I get very easy sea sick 😂😂
Hey! Min XT350 ryger fra udstødningen og der er olie både på silencer og på venstre side af cylinderen. Kan det være pakningen bare? Eller også Valve Stem Oil Seals? tak!!
Hei! Går ut frå at du meiner eksosporten til sylinderen? Altså der eksosanlegget er festa til sylinderen?
Dersom det er vanskeleg å få sett skikkelig, ville eg tatt av tanken. Då ser du toppen og sylinderen litt bedre.
Eg trur kanskje du har ein lekkasje fra enten pakningen til toppdekselet eller pakningen på ein av toppdekselboltane. Lekkasje frå desse vil kunna renne ned på eksosanlegg og langs sylinderen som du seier at det gjer på din.
Dersom du ikkje har sjekka ventilar på ei stund, ville eg samtidig ha bytta desse pakningane. 🙂
@@halvardollikainen3999 Thanks! I just bought new valve stem seals - are those the ones you refer to? I see the oil coming out on the side of the cylinder (not near the exhaust connection) and then at the very tip of the silencer in the rear back where it smokes like crazy. The exhaust does not seem to have any holes at least (the smoke it the perfect check for that :D )
If it was leaking from the top or between the top and the cylinder, I would consider replace cylinder cover gasket and seals for cylinder cover bolts. These are not the valve seals. But in your case, it sounds as it might be valve seals or leakage through piston rings?
A leak down test og compression test will verify this. Is it running strong and starts easy?
If the piston and cylinder have high mileage and are original, it might be time to inspect and consider servicing 🙂
@@halvardollikainen3999 uhh. yeah it has high mileage but it normally starts and runs perfectly. I have already bought the seals and the valve cover gasket so will replace these and see if that works! thanks so much!!
Lykke til 😊👍