Відео

Thank you 😊

Takk for kommentaren 😊. Det er nok bedre med eiga stemma i forhold til AI, men eg er så dårlig til å gjera to ting på ein gong 😅. Det blir mykje stamming og ehh, hmmm. Hehe 🙂. Men eg må kanskje berre gå inn for å prøva meir. Håpar du får til å lese dette. 🙂

@@halvardollikainen3999 Jeg har full forståelse for utfordringene ved å filme/kommentere! Voice over er kanskje beste alternativ? Allen Millyard gjør det og det fungerer veldig bra syns jeg. Han blander på en fin måte å snakke til kamera, filme innimellom og voice over. Det handler egentlig om å fortelle en historie. Ser deg i neste video!

Håpar det 😊

Ja, kanskje jag gör så 🙂.

Agreed! I don’t know for sure, but I am leaning to a theory that all the metal particles and flakes is from an earlier breakdown. Possibly a melted piston and that the bottom end of the motor was not touched. But I do not know for sure.. all inside of the motor looks ok, except gor signs of general wear from the particles..

Thanks a lot 😊! Appreciate it. Still lot to do, but it is just as much about the journey as the final result 🙂

Thanks for the comment 🙂. Sorry to hear about your oil change. This weekend I tore down the engine and split the case. Lots of cleaning in near future 😅. Plan to make an episode out of it. 🙂 hopefully the engine case halves and cylinder head is usable..

Guess it is not for all, but some of us are wired that way 😅. Chevy van? They can be cool! A lot of car (like big) to fix if it has rust issues I can imagine 🙂

@@halvardollikainen3999 yep .. here in nothern europe where we have tons of salt on a roads during winter .. no chances to escape rust .. I have chevrolet astro AWD , listed it by 5 cm, instaled transfer case from chevy blazer and made it 4x4 , also many cuts and welds and on top raptor paint. lots of nerves and time

Thanks 😊

Thanks for the comment! I have not found time to investigate it yet. Just removed the engine and placed it on my work bench. Soon hopefully 🙂.. kind of looking forward to dig into it. I hope it is something that can be fixed. 😅

Takk for kommentar 🙂. Motorblokka står endå på arbeidsbenken. Håpar å få sett på det snart. Sjølv om problemet er på clutchsida er nok heile motoren full i små metallbitar. Så trur den treng ein grundig rens innvendig. 🙂

Thanks for the comment 🙂. Hope the crankcase is still usable. I have very bad experiences with buying «good and working» used parts like that 😅

@@halvardollikainen3999 I have 8 old motorcycles in my garage and all of them have issues .. so I understand what you say

But if you are like me, it is much more more satisfying to work on an old bike, than looking on a new. Guess it sounds kind of weird, but makes sence to me at least 😅

@@halvardollikainen3999 well I love and hate in a same time ... stockholm syndrom :). Old stuff has more spirit and people appreciate it , but often it cost a lot of nerves.. no it not weird - for me its normal . keep on

Thank you for the comment 😊. If I can do it, so can you. Good luck 😊👍

@@halvardollikainen3999 Thank you!

Thank you and thanks for the comments 😊. I plan to make some content with the xt, both in use and working on it. So feel free to check another time 😊

@@halvardollikainen3999 awsome will do for sure

Hi! Good te hear these old dual sport bikes are still taken care of 😊👍. Most parts that I replaced was original parts still available from a yamaha dealer. Strangely, the diaphragm in the secondary carburetor (right side) is discontinued and not possible to get new original part. Quite stupid, as this is one of the most likely parts to go bad.. that diaphragm I bought from a seller on ebay (after marker part), but it works great. And installation was relatively easy, as long as you dont screw up the glueing part (which I did the first try 😅). I think you will find a seller for a similar diaphragm by searching «diaphragm xt350 carburetor». Good luck 😊

@ thank you, i’ve found and ordered the parts from eBay as you said! Can’t wait to get it going 👍🏼

Moi! Thank you for the kind words 😊.

Hei! Går ut frå at du meiner eksosporten til sylinderen? Altså der eksosanlegget er festa til sylinderen? Dersom det er vanskeleg å få sett skikkelig, ville eg tatt av tanken. Då ser du toppen og sylinderen litt bedre. Eg trur kanskje du har ein lekkasje fra enten pakningen til toppdekselet eller pakningen på ein av toppdekselboltane. Lekkasje frå desse vil kunna renne ned på eksosanlegg og langs sylinderen som du seier at det gjer på din. Dersom du ikkje har sjekka ventilar på ei stund, ville eg samtidig ha bytta desse pakningane. 🙂

@@halvardollikainen3999 Thanks! I just bought new valve stem seals - are those the ones you refer to? I see the oil coming out on the side of the cylinder (not near the exhaust connection) and then at the very tip of the silencer in the rear back where it smokes like crazy. The exhaust does not seem to have any holes at least (the smoke it the perfect check for that :D )

If it was leaking from the top or between the top and the cylinder, I would consider replace cylinder cover gasket and seals for cylinder cover bolts. These are not the valve seals. But in your case, it sounds as it might be valve seals or leakage through piston rings? A leak down test og compression test will verify this. Is it running strong and starts easy? If the piston and cylinder have high mileage and are original, it might be time to inspect and consider servicing 🙂

@@halvardollikainen3999 uhh. yeah it has high mileage but it normally starts and runs perfectly. I have already bought the seals and the valve cover gasket so will replace these and see if that works! thanks so much!!

Lykke til 😊👍

Thanks for the comment 😊! Yes, I got it sorted. Been using the bike on small trips and commuting to work when the weather permitted this summer. Really crappy weather, so it has not been used too much. Agreed, they are great bikes. Drove a similar dual sport moped (50cc) when I was 16 and it brings tons of nostagly and a little more power than the moped had 😅.

It’s the inside that counts 😅

Thanks! I like the bike a lot 🙂👍! Just like the 50cc dual sport mopeds I drove when 16, just a bit faster 😅

Den blei litt friskare og sprekare. Kjekt når jobben gir positive resultat 👍. Sikkert rom for finjustering, men nå føles den sprek og fin å kjøra 🙂

Takk 😊. Det skal eg gjera, hehe 😅👍.

Hi! Thank you for the kind words 😊. The kick axle is expensive, but What can you do… I wanted it to be fixed and looked away when I paid the money 😅. I guess the norwegian currency don’t help you, so I answer in dollars. It cost 300 us $ for the axle (or somewhere around there).

Godt med alt som er gjort 😅. Nei, eg syns det er lika kjekt å jobba med sykkel som å kjøra, så det går fint. Ventar på litt delar til forgassaren nå, så blir det spennande å sjå resultatet etter ein skikkelig rens, nye pakningar og byte av ein dårlig membran. Eg tok sjansen på å svara deg på norsk, sidan du skreiv litt på svensk 🙂.

@@halvardollikainen3999 jag gjorde samma sak med mina förgasare för 2 år sen ... nu går den mycket bra å är då lättstartad :-) ..jag ska bara kolla ventilerna nu till vintern

@@Xt350-fz6gc høyrest veldig bra ut! Gler meg til å testa resultatet når eg er ferdig med min forgassar 😊..

Thank you for the comment and subscribing 😊. Had almost to travel to the orkney once. Was on a job on a well boat at shetland, and would have to sail to orkney if we didnt finish the job before they had to sail. Nothing against orkney island, but I get very easy sea sick 😂😂

Hej! Svenska och norska er inte så olika, men usikker på vad du menade😅. Tenker du på sikkemaskina(bead roller)? Den som eg laga dei forsenkingane med? Den er ganske biltema blå ja, hehe. Men den kjøpte eg på expondo. Ikkje noko vondt å seia om biltema altså, har kjøpt masse der 🙂

@@mattdrat3087 takk for fin tilbakemelding 😊. Kan godt vera at det kjem meir om den og 🙂

@@mattdrat3087 really like the old dual sport bikes. They give an impressive amount of driving pleasure for its engine size 😊

@@halvardollikainen3999 They do! They are simple, functional and don't way a quarter of a ton!🙂

Many thanks 😊! I can imagine there are many roads and places that a XT350 or other dual sport bike would be really fun to drive in South Africa also 😊

Thank you so much 😊

Da har du nok ja 😊

Hei! Har ikkje kameraet tilgjengeleg nå, men ser ut som filene er: 1920x1080 og bildefrekvens 48hz. Ser ut som filmane blir ca 100 mb per minutt 🙂

So true! 😊😊

Thank you for the nice comment :-)

Thank you 😊😊.

I also have one. It's old but still works, but not smoothly.

Nice 😊👍! I’m looking forward to see it more complete. Like the cars. Simple and robust mechanics 🙂

@@halvardollikainen3999 In Vietnam, spare parts are very rare.

@@truonghung8933 yes, know what you mean. Lots of original parts are not available. The Galloper seems as a child that none of the parents want to take responsibility for anymore 😅

You are certainly right! Thank you for the correction 😊

Thank you! It means a lot to get commens like that ☺

Thank you 😊. Google translated the comment for me. Yes it takes time to deal with the rust, but it is something that I want to learn and to become good at 🙂.

Thank you 😊. Just a beginner, but fabricating new panels and repair patches is something I find very fun and rewarding to do 🙂

Thanks for the comment. I really think these cars are coming classics. There are still many around here in Norway but they suffer heavily from rust and I think there will be a lot less in just a few years. Cool looks, good 4x4 system and solid mechanics, whats not to like 😅

Takk for fine ord 😊. Håpar jo nokon syns det eg gjer er kjekt å sjå på og kanskje tilogmed litt inspirerande 🙂

Utruleg kva ein gjer når ein har bestemt seg for at noko er gøy 😅

Fine dagar uti februar så kan da alt byrja bli ganske så triveleg på ein lun solflekk 🙂

Absolutely 😊

Thank you for the kind words 😊. Nice to hear from you! Almost all bolts on lower and upper control arms sheared off and many more. So I believe you 😅. Some small things left on the chassis before I start on the body. I have some welding to do too. Here in norway salt is used during winter time also. The cars really suffer. I agree about the cars! Simple and robust mechanics, capable 4x4 and very little electronics make it a good for what I want to use it for 🙂. (Don’t plan on breaking any land speed records soon 😂)

Tenkte sitta på girkassen og starta bilen i gir 😅

Thank you for the nice comment :-)