Thanks for this tip I used it yesterday, I had to put a bit of heat on it as well with a hot air gun but the stubborn little shit came out! Very satisfying 👍👍
Cheers bonnie lad! Half the time you can leave the carb on the bike. Simply loosen the hose clips, turn off petrol, pull off petrol pipe and rotate the carb thru 90 degrees towards you with a bowl to catch the petrol. Then remove the float bowl to gain access to, and remove, the float retaining pin. Theres always one of the four float bowl screws that wont come off. In this case remove the 3 easy ones 1st then pull the opposite corner of the float bowl gently away from the carb and it'll "crack" the last screw.
Couldn’t hardly understand a word, accent is super strong. Cheers! 😅
Geordie it’s easy to understand.
They sound so goofy 🤣
Gods land ain't it
Thanks for this tip I used it yesterday, I had to put a bit of heat on it as well with a hot air gun but the stubborn little shit came out! Very satisfying 👍👍
More than welcome. Glad it helped you out
Quick wisdom, thanks a mil!
Cheers bonnie lad! Half the time you can leave the carb on the bike. Simply loosen the hose clips, turn off petrol, pull off petrol pipe and rotate the carb thru 90 degrees towards you with a bowl to catch the petrol.
Then remove the float bowl to gain access to, and remove, the float retaining pin.
Theres always one of the four float bowl screws that wont come off. In this case remove the 3 easy ones 1st then pull the opposite corner of the float bowl gently away from the carb and it'll "crack" the last screw.
Wiw great idea. I never thought of this trick. I'll have to use this next time I do anseat replacment.
Thanks I bought a defective carburetor and the fuel flow is very slow into the bowl I'll try this and run a wire through it
Thanks!!!!!
Hello, how do you press in det new one? Would highly appreciate a fast answer!
Normally just pop in with a good press of the thumb
Where do u get the seat???
Normally in a full rebuild kit. Or look at the parts diagram for your bike
What size tap
any that will fit
There’s a tool for that lol
most people already have a tap and die set .got to piss with the cock ya got
You definitely don't hold a carb in the vice like that
scrap carb mate . more the let me film at the same time