Hey I got a question. If I wanted to use a different D comp, lets say I want to use D44 for T14... how can I do this? I cheated by adding T44 to the pot list even though there wasn't a tool there and just adjusted cutter comp on T44 D comp. section.
Is this a P300 or P200 control? If its a P300, I suggest using DA, DB, and DC instead of D14, D44...etc. Wait! I haven't done a video on that yet?? I'll get right on it!
How do you set to show the wear columns on tool length and cutter comp offsets? Mine is P300M as well but doesn't show it.
That’s an option from Okuma. You’d need to contact your Okuma retailer
THANKS FOR SHARING
Do you how to set tool length by using renishaw system on the control
Hey I got a question. If I wanted to use a different D comp, lets say I want to use D44 for T14... how can I do this? I cheated by adding T44 to the pot list even though there wasn't a tool there and just adjusted cutter comp on T44 D comp. section.
Is this a P300 or P200 control? If its a P300, I suggest using DA, DB, and DC instead of D14, D44...etc. Wait! I haven't done a video on that yet?? I'll get right on it!
@@pocketcharleywithgosiger lol yes! Make a video please! It's a P300 on an M560-V