Diagnosing Gen 1 Sequoia ABS VSC TRAC lights - ONCE AGAIN

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 9

  • @leer.9641
    @leer.9641 Рік тому +2

    The YAW sensor on the ‘02 Sequoia is under $50 and takes about 15 minutes to swap out. Mine is under the console as well and I swapped it out about an hour ago. My VSC and TRAC OFF lights were going on intermittently and causing an awful grinding noise within the ABS system. Once the lights came on (VSC and TRAC disabled), the grinding would stop. Now the lights are on, but no more grinding. Never had the CEL come on.

    • @CliffjumperCars
      @CliffjumperCars  Рік тому +1

      That's a notorious culprit, and so are the steering angle sensor, both of the brake light switches (one on each brake pedal), and the thrust sensor in the brake booster. Lots can go wrong that causes the VSC/Trac/ABS system to be unhappy.
      Also worth mentioning that when you replace the Yaw sensor or the steering angle sensor, you have to do a zero point calibration.

    • @jayball2752
      @jayball2752 10 місяців тому +1

      Did that fix the problem? I just had this same thing happen to my 01 sequoia

  • @brettstover1850
    @brettstover1850 Місяць тому

    My 2003 abs light is on. I had the frame replaced by Toyota under recall. They never did say what or why. Just that they don’t know 🤷‍♂️

    • @CliffjumperCars
      @CliffjumperCars  Місяць тому

      Replacing the frame is a MASSIVE job, so I'm not surprised if ABS sensors got messed up in the process.

  • @surak24
    @surak24 Рік тому +3

    Whats the problem? And solution?

  • @abubakerzarrug5614
    @abubakerzarrug5614 Рік тому +1

    Thanks for sharing.. regards from Libya .. I had my first gen. Sequoia only two months ago

  • @rawimpact
    @rawimpact Рік тому +4

    So it told you the problem was every problem that can cause this issue