EcoTech VorTech Alignment and Dryside Spacer Usage

EcoTech VorTech Alignment and Dryside Spacer Usage. (MP10, MP40, and MP60)
All VorTech pumps should
*Never run a submersible pump (like the VorTech) out of water as it can damage the pump.
1. Measure your glass.
2. Choose the correct spacer (varies between MP10, MP40, and MP60 pump).
3. Apply the spacer to the Dryside (motor)
4. Choose mounting location (Tip: too high will suck air, too low may move your sand bed - avoid obstructions in the tank eg. rock work - the more open space around the pump the more overall water movement you will achieve)
5. With the pump turned off attach the pumps and use the hanging tab. The hanging tabs are intended to protect the dryside from falling and being damaged. In the event that you do not mount the tabs above the VorTech - make sure that the tab is less than half the distance between the motor and any surface the motor could fall and make contact with.
6. Make adjustments in alignment until there is no noise or excessive vibration.
7. Adjust/Program your VorTech as needed.
Thank you for watching: Don't Forget to Subscribe!
ua-cam.com/users/EcoTechMarin...
Please remember that EcoTech does not regularly monitor forums or social media feedback but we are always available and always happy to hear from you. For comments and/or assistance please contact a representative directly at: [e-mail] or by calling 1-800-785-0338 Ext. 2. Chat support is also available through support.ecotechmarine.com/hc/... Service hours are 9AM-5PM EST M-F.