Viewers be advised: (1) Oil drain is normal right-hand thread. (2) Never use a torque wrench to loosen fasteners, you will ruin it (3) Add 3.7 quarts, no more. (Oil level must be checked when oil is hot, not cold, in dry sump systems.) (4) Recommended viscosity for this vehicle per BMW is 5W-40 synthetic. Do not use 20W-50 in this motor with its small clearances, you will have premature wear. (5) Oil filter torque is only 8 ft lbs, or 3/4 turn past when gasket touches surface.
don't think using 20 - 50 OIL is appropriate, however warm the climate is.More stress on the oil pump and it will take a fraction long to work around the galleries and therefore could lead to more internal wear. The water cooling should do its job.
Viewers be advised: (1) Oil drain is normal right-hand thread. (2) Never use a torque wrench to loosen fasteners, you will ruin it (3) Add 3.7 quarts, no more. (Oil level must be checked when oil is hot, not cold, in dry sump systems.) (4) Recommended viscosity for this vehicle per BMW is 5W-40 synthetic. Do not use 20W-50 in this motor with its small clearances, you will have premature wear. (5) Oil filter torque is only 8 ft lbs, or 3/4 turn past when gasket touches surface.
Beast mode, thanks for all this info!
Good
Thanks, about to do Oil, Spark Plugs, Coolant, and Starter remove and clean on my K1300R.. This will help.!
drain plug on bottom is counter clock wise as viewed looking at it, use new washer, torque wrench it to spec.
drain plug on bottom is counter-clockwise to loosen ( right hand threads). With left-hand threads, you would turn clockwise, to loosen.
don't think using 20 - 50 OIL is appropriate, however warm the climate is.More stress on the oil pump and it will take a fraction long to work around the galleries and therefore could lead to more internal wear. The water cooling should do its job.
Замену произвести можно и так не снимая ножку!!!, я менял лично не снимая, поставил фильтр hello 160
Help. So the dip stick guide fell into the oil reservoir when i was putting the dip stick in. Will this be a problem leaving it in there?
Clockwise to loosen?? looks like the drainplug is right treaded and counter clockwise to loosen. Hell, you got me unsure... LOL
Make sure you haven't caught the plastic bag between your filter and your bike, else you're foooked!
wow, the maintenance of this bike is pure garbage!! Worst dessign ever made! You have to dismount the gear lever, LMAO 🤣