WD40 is not recommended for chains coz it has chemical agents/properties and gets into O rings of chain and damages the rubber inside the O rings and chain starts giving a permanent noise. Then u have to change entire chain and sprocket set. Kerosene or petrol is a good cleaning agent and it vaporizes immediately. For rest of the parts it's ok to use WD40 👍
I only use WD40 on my chains. It’s perfectly safe with the advantage that dirt doesn’t stick to it very well. I get 50 thousand km on my chains without any worries. It does not damage O rings.
@@jaywhoisit4863 the problem is wd40 is drying the chains, cause its an anti rust, so u need to kinda rub more oil to the chain after you put the wd40 or just roll the tyres and let the chain wet them self inside the gearbox :v
The I rings are fine with WD40. I've seen a bike channel soak o rings in a test tube full of WD40 for a month. The o rings were fine with it. It's just a myth that is damages then.
Please don't use it on disc pad WD40 is kind of rust remover and lubricant. I did a mistake in royal Enfield Thunderbird I applied WD40 in order to remove rust but unfortunately it went to disc pads literally no brakes front and back and then it was taken to show room to change pads. Please use sand paper to remove rust for wheel portion please
Hello... Can i use for rust in painted parts of bullet 350. Rust in tank cover, rust in air filter cover etc.. Plz give any options to remove rust from these parts ...
Only use this on your chain if you want premature wear. It will break down and penetrate the rubber o rings and cause the internal grease to become exposed to the elements leaving you with a shitty chain.
Very nice, however never use WD-40 on sparkplugs instead burn them with a weed-burner of something! Why a sparkplug can handle very high temps an rather burn it clean. For the rest, perfect use! however only to clean because it leaves an oilfilm and this will attract dirt, rust etc so i rather use Litium soap based grease for the footpegs, shifter standard etc. Btw another top-tip spray the complete engine with WD-40 let i soap overnight en clean in with an rag end use a stick to clean up the difficult area, then clean the engine and it will be like new.
Other than a degreaser/water displacer, it is a poor choice. For moto & push bikes. 👎 Never use this garbage as a lubricant. Unless you don't care too much about your equipment.
No please not on a O- or X-ring chain! It will get into the links and mess with the grease inside! WD-40 can not deal with the high forces on a bikes chain! Need to use grease! For your chain use Diesel / Kerosene for cleaning and ideally chain grease. That is cheaper too! I would not use WD-40 on any rubber parts as some rubbers can be damaged by WD-40. Remember it's not just oil it can be aggressive loosening rust! Use it on bolts and mechanic parts that do not need to transfer a lot of force. WD-40 is not viscous enough to lubricate under high pressure!
I can smell the WD-40 through the screen
It's carcinogenic. Never smell it
I've found the best success spraying almost everything and just wiping down the whole bike. It's very quick
One of the best videos on the wd40 uses thanks for taking the time to make this video really helpful
😎👍🇬🇧
Wd 40 is flammable guys remember
Nope
Good product but surprisingly you had 16 problems at the same time in your bike. Not surprisingly its RE ;). I own one..
0:15 Maintain that throttle housing by tightening the screw on it before worrying about the switch?
Nice sharing idea
6:44 Look at the name its not wd40 its rust cleaner. Thats why the liquid is kind of yellowish color because wd40 is white
Right bro ... lol
WD40 is not recommended for chains coz it has chemical agents/properties and gets into O rings of chain and damages the rubber inside the O rings and chain starts giving a permanent noise. Then u have to change entire chain and sprocket set. Kerosene or petrol is a good cleaning agent and it vaporizes immediately. For rest of the parts it's ok to use WD40 👍
I only use WD40 on my chains. It’s perfectly safe with the advantage that dirt doesn’t stick to it very well. I get 50 thousand km on my chains without any worries. It does not damage O rings.
Check out the video of MC Garage on WD40
@gonein
@@jaywhoisit4863 the problem is wd40 is drying the chains, cause its an anti rust, so u need to kinda rub more oil to the chain after you put the wd40 or just roll the tyres and let the chain wet them self inside the gearbox :v
The I rings are fine with WD40.
I've seen a bike channel soak
o rings in a test tube full of WD40 for a month. The o rings were fine with it. It's just a myth that is damages then.
Its very true beware to chaine using wd-40
Japanese always remind me that at the work place
Don't use on bike chain. WD-40 is a penetrant. It will go inside the O/X rings, expose the grease inside the seals and damage the chain.
You can use it to CLEAN the chain before applying actual lube to it.
Ty bro
WD 40 will not damage o rings, but its not a good lubricant
ua-cam.com/video/Fzyk4nq3ug0/v-deo.html
For low-end chains only.
Thats why its purpose is cleaning and not lubing 😊
One of the most have on hand. Wd40
Awesome video bro
thank you very much
Thanks a lot bro..
and what lubricate also brake discs?
dont use it on your brakes holy shit lmao, are you trying to kill this man
That's pretty cool one 😍😍😍
Woah wait isn’t this bullet guru video?
... and it's also recomended on vegetables 😆
Good one
All in one boldo bhai 🤣🤣👍👍🤞
Don't use in the long run. It damages the surface.
to clean the chain you just need kerosene cheap and not harmful to o ring
Jitu bhai superb
can wd40 help me find my dad to ?
Why not
You can try
😂
Is it suitable for removal of front Disk Rust? Or it may harm my front disc?
Please don't use it on disc pad WD40 is kind of rust remover and lubricant. I did a mistake in royal Enfield Thunderbird I applied WD40 in order to remove rust but unfortunately it went to disc pads literally no brakes front and back and then it was taken to show room to change pads. Please use sand paper to remove rust for wheel portion please
Use white vinegar to remove disc rust
Don't use..
I also did the Same mistake on my classic 350 we should not use WD40 on brake related hardware.
Nice Bike 👍
How frequently this should be used?
1 time per month
Thank you very very very much .
Very nice & informative also background music lovely enjoy much where can I get this tune name please
Various dreams, song by ecliptix
Aap ka jaisa same disc lock meri paas v hai, apka key dekhke pta chla
Hey honey, since you're going to the store can you grab me some hair spray? Heck use some WD40!
Nice 👌
How to buy this ?
Use CRC spray its not flamable
Doesn't it affect on electronic parts like switches ?
Key places ??
Its non reactive. But wipe after applying immediately so it doesnt collect dust.
the wd40 said they are non conductor liquid, they even provide special can for electronics purpose. Give it a go
@@vicemafia23 thank youu 😊😊
it is not a lube,,never was meant to be ,no it wont harm switches it is a water displacement
Smell is here
well done *
Can we use it as a chain lube?
Nooooooooo, only for clean purposes
No it’s not a lubricant mate
It’s perfectly fine as a light lube. I apply every fuel stop.
Isn't that bad lubricating the sparkplug???
WD40 is not a lubricator... but a cleaner
do not use wd40 in hot surfaces i tried it. It got smoking.now i have to change the sparkplugs
Nice video
your not suppose to use wd-40 for inside of lock cylinders either. this video is just ALL wrong. not sure if this is a troll video or what?
Yeah that's a good call either that or the guy who put the video up is just an idiot
Funny how he is not even using wd40 but something similar,no one noticed?
Oddly satisfying video😃
After half or one hour..it will came back in same condition
hala ginagamit na nya sa lahat ng parti 😂kaloka..
Apply chain spray after using WD40. It's a cleanser not a lubricant
Not necessary. The chains are internally lubed. The light Wd40 protects the chain from corrosion perfectly fine.
Can. You. Make. A. Sandwich. With. It. Lol.
Yes ....
My condolences in advance
Don't.use.on chains too often . Wd40 is repaire liquid and not just lubricant.
Wd40 is must for re owners
Very informative...
Glad you think so!
Hello...
Can i use for rust in painted parts of bullet 350. Rust in tank cover, rust in air filter cover etc..
Plz give any options to remove rust from these parts ...
PB blaster and steel wool
Use metal polish by wavex or autosol they work wonders
Great video, but don't ever use WD-40 for cleaning your chain
Very nice video is really WD40 or an other product sir? 😊😊😊😊
What u r using in this video is not WD-40. Something rust cleaner is written on the can..
Pwede Ang used oil dyan pgwala kang wd40
pre parang mali ung wd40 sa sparkplug anu
Only use this on your chain if you want premature wear. It will break down and penetrate the rubber o rings and cause the internal grease to become exposed to the elements leaving you with a shitty chain.
So is it okay to use on chain that doesn't use o ring?
it's safe in o ring
Very nice, however never use WD-40 on sparkplugs instead burn them with a weed-burner of something! Why a sparkplug can handle very high temps an rather burn it clean.
For the rest, perfect use! however only to clean because it leaves an oilfilm and this will attract dirt, rust etc so i rather use Litium soap based grease for the footpegs, shifter standard etc.
Btw another top-tip spray the complete engine with WD-40 let i soap overnight en clean in with an rag end use a stick to clean up the difficult area, then clean the engine and it will be like new.
05:44 how
It's not wd 40
Now i know....
Can I use disc break pad clean
Yeah use the whole can! 🤣
No
😳✌
Spray to dhyan she Karo kit na waste ho Raha hai
You are not using WD40
can I
Unnecessary.
I guess Royal Enfield riders have fear of rusting deeply rooted in them.
Buddy my Spark plug has been stuck in my Jupiter . How to remove it with out breaking
Spark plug wrench mate, most shops/stores do them, they also sell the separate attachments to be able to realise the spark plug with ease
It is nott WD40 u r using Kangaroo rust cleaner
be careful, wd-40 eats metal!
🤦♂️
Spraying WD40 on engine case and exhaust pipe area will lead to white smoke....
what happened after that ? was there any problem?
Yes i am facing the same issue
No
Hm
Bull shit , indian bikes please don't use WD40 I lost my ktm rc 200 because of this WD 40
How?
👍🏽👍🏽👍🏽👍🏽
Cheat......He is not using WD40....check the can closely
Wastage of money. Use kerosene/petrol
WD 40 is expensive
No
You are using different rust spray and making video in the name of WD-40
After viewing this video I purchased WD40 online, but found useless, even can't remove mustard oil from surface, fake video
You shouldn’t use wd40 for almost any of this shit
Other than a degreaser/water displacer, it is a poor choice. For moto & push bikes. 👎
Never use this garbage as a lubricant. Unless you don't care too much about your equipment.
No please not on a O- or X-ring chain! It will get into the links and mess with the grease inside! WD-40 can not deal with the high forces on a bikes chain! Need to use grease!
For your chain use Diesel / Kerosene for cleaning and ideally chain grease. That is cheaper too!
I would not use WD-40 on any rubber parts as some rubbers can be damaged by WD-40. Remember it's not just oil it can be aggressive loosening rust!
Use it on bolts and mechanic parts that do not need to transfer a lot of force. WD-40 is not viscous enough to lubricate under high pressure!
Check UA-cam someone did an experiment. It does not harm o rings
Aiyoh! Waste of time! Bro, kindly upload videos of something new! All these videos are already done by so many! Wastrel!
Yes
@@purnimasahu8853 ama samy podatha
Wd40,developed by NASA for the space shuttle!👍
Try spraying this to the disc brake. Thank me later
wd40 should NEVER be used on disc pads
Half knowledge is dangerous and your comment proves it
No don't #experience
Can we use wd 40 for electrical contacts ?
Yes I have tried it
Better off with silicone, its dielectric