@@OniMX5 I got the listing from the creator of my board and it is pin 26 in my case. Maybe you need to ask the manufacturer of your board. Because I don't know how to help you :(.
@@OniMX5 I don't know how it is done, because I have a plug and play board. I simply select pin 26 in the programmable outputs tab, which activates the MIL
What settings are you using? Mine won't cut ignition and drop rpm when doing a flatshift. Launch control works good tho
Hey, my setting is:
Common Engine Protection tab:
Protection Cut: Both
Cut Method: Rolling
Protection RPM Limit 3500.
And in FlatShift tab:
Soft rev window: 300.
Soft limit absolute timing: 0
Launch/Flat shift switch RPM: 5000.
Does your check engine light act as a shift light? If so how?
Yes, I just use the rule (programmable outputs) that triggers the CEL if the RPM is higher than 7000.
@@TheCzarobest how could I figure out which arduino pin to use?
@@OniMX5 I got the listing from the creator of my board and it is pin 26 in my case.
Maybe you need to ask the manufacturer of your board. Because I don't know how to help you :(.
@@TheCzarobest will do. Did you use an analog pin?
@@OniMX5 I don't know how it is done, because I have a plug and play board. I simply select pin 26 in the programmable outputs tab, which activates the MIL