Ok- I’m not sure what high school this was filmed at- but I have no idea what he made or used the box for. At the 7 minute mark I was ready to install a ballast and wiring
It's a router sled, with a flattening bit it's used to do just that - flatten pieces of wood. Typically end grain or large slabs to big for a thickness planer
Very good but your dust extractor isn't being used enough you may have a mask but the dust will go everywhere in your workshop and be moved about all over just an observation I suffer with a bad chest so it is so noticeable
تمام مدت منتظر یک ابتکار جدید بودم ولی نشد که بشه !!!
Just a DIY planer that's not all that sturdy, and with a more complex build out than was needed (use strips instead of cutting out the middle).
Great job
Thank you so much for watching.
Hola EASY MAKE , muy buen proyecto felicidades y gracias por tú valioso tiempo.
Super banaya bhay
Keren hasilnya 🎉
One question why did you have to drill twice before fixing with screws, the first was a countersink but then you used a second drill bit?
screws were longer than the countersink might not be absolutely necessary but not a bad habit in the edge grain of plywood
Ok- I’m not sure what high school this was filmed at- but I have no idea what he made or used the box for. At the 7 minute mark I was ready to install a ballast and wiring
It's a router sled, with a flattening bit it's used to do just that - flatten pieces of wood. Typically end grain or large slabs to big for a thickness planer
Llllllll
L
L
L
В мастерской имеется рейсмус , а с этой лабудой топорная работа получается.
Safety tip. Never let go of a spinning router.
Very good but your dust extractor isn't being used enough you may have a mask but the dust will go everywhere in your workshop and be moved about all over just an observation I suffer with a bad chest so it is so noticeable
Годно!👍👏
Дякую за перегляд.
@@easymake414 дякую за вiдio
👍💪🤝
Мне не понадобится!
👋👍
It won't be needed in my workshop. If I need to thickness an area I would use my CNC router.
Без того пристрою,що циклює наврятче!
Waste of materials and time rails too high and need better guides on bottom. Poor technique used.
Please title your videos!
+
What a complete joke and a waste of time and lumber…