Brushless ESC Review, & Setup ZTW Shark G2 30a 32-bit RC Boat Speed Control
Вставка
- Опубліковано 25 лип 2024
- ZTW SHARK G2 32-bit ESC
www.ebay.com/itm/176071846307...
Thanks for Watching Ironclad Rc Tinker test and tune everything
Personal contact information ironcladedout@gmail.com
Thank you so much you helped me to get my boat working👍😊
Hot dam won't be long now and we'll finally get to see that thing run! Can't wait!
I've been wanting to try one of those sharks.👍
Hello
C est un tres bon variateur, je l utilise en 50 amp en 3s et 4s sur mon catamaran de 40 cm avec un tenschoc viper1515/ 4000kv.
thanks for the info! I have just ordered a couple of the 50amp to for small jetboat and the tyxin768 also subscribed !
Big b i have a request. Can you show us how to solder the end of a flex cable and possibly the flex cable to prop tip. Thanks
I'm building the 21"twin cat as you know and I did look at these esc. I didn't like that there wasn't a 90 amp because I wanted 20 percent more esc amperage than the motor requires, and second the programming card was more than the motors like you said. Also i didn't like the water cooling they had going on, or not going on. It just wasn't enough for these motors. Anyway I went with 2 reliable flycolor 90. Can't go wrong with those and I have the room, barely. Bg4l
I’ve had no luck at all with ZTW g2’s and these shark g2’s ZTW don’t warrant either they just argue till you give up, the 130 amp g2 caught fire and nearly destroyed my boat.
Good luck with it.
I'm wondering if you know how I should program the ESC to make it stop automatically when it loses connection from the transmitter. I turned off the transmitter before I unplugged the battery, and the motor went to full power. Thank you!
May I suggest an outrigger ? (two outrunners on one solid shaft perhaps ?)
You've seen the kind of props they use ? Reminds me of the leaves of a tulip..
Hand finished out of VERY rough castings.......I'll try getting some of those,
Will send one if desired (and all goes well) Keep you posted......
what kind of brushless ?
Bro which motor will be best for my 17 inch catamaran ? Motor under 9 dollars 😢
X-team 2440 4500kv was a good motor for my 17' catamaran 40a speed control, and you're in business. Unfortunately it's a little more than 9 bucks
May be intended for bigger hulls (yes) but can we see a twin outrunner cat / rigger / mono
in (near) future ? I do like the scream of those.......
An Asian guy mounted 7 outrunners on 1 solid shaft long hull outrigger. Wow !
I saw that 7 outrunner setup. It looked cool as hell! 👌 Planning another twin build, can't decide on the hull.
Hi fellow, Have these shark esc proved reliable in your use?
Yes, I've had great success with this one.
@@IRONCLADRC ahh thanks for the reply I have just ordered a couple of the smaller 50 amp ones , small jetboat mod inbound!
That esc is Tiny