Kevin, great video. Just made my second order with BCH. Here's a tip for the 902XL: use a heated push pin or (better yet) a small metal pick to melt a small hole in the fill ball. Then use a small screw or picture hanging eye to thread into the ball. Pull on the screw or eye with pliers to remove the ball. Then use a 9/64" drill bit by hand to remove the little bit of plastic that was below the ball. Otherwise neither the clear nor colored 4mm plugs will seat completely into the 902XL cartridge.
Kevin, at 0.49 you show an exploded view of the Cartridge there is a space between the fill hole and the end of the cartridge. Why can’t a hole be drilled there and fill through that hole instead of messing around with the plug. . Can you just drill a 4 mm hole and the plug it?
This is fantastic. Thank you so much. I will happily circumvent the instant ink ripoff. When removing the sticker on the black cartridge I noticed a smaller hole higher up. From the image at 1:09 it would seem to be right behind the 'K' and should lead to the other chamber. Could ink be injected there?
Kevin, You just saved me a bunch of money on cartridges! Ordering refill kit from your company today.
Thanks
Kevin, great video. Just made my second order with BCH. Here's a tip for the 902XL: use a heated push pin or (better yet) a small metal pick to melt a small hole in the fill ball. Then use a small screw or picture hanging eye to thread into the ball. Pull on the screw or eye with pliers to remove the ball. Then use a 9/64" drill bit by hand to remove the little bit of plastic that was below the ball. Otherwise neither the clear nor colored 4mm plugs will seat completely into the 902XL cartridge.
Kevin, at 0.49 you show an exploded view of the Cartridge there is a space between the fill hole and the end of the cartridge. Why can’t a hole be drilled there and fill through that hole instead of messing around with the plug. . Can you just drill a 4 mm hole and the plug it?
This is fantastic. Thank you so much. I will happily circumvent the instant ink ripoff.
When removing the sticker on the black cartridge I noticed a smaller hole higher up. From the image at 1:09 it would seem to be right behind the 'K' and should lead to the other chamber. Could ink be injected there?
i don't think so because thats in the top chamber where the sponge is... it blocked mine up
Isn’t there a chip on this cartridge that bricks them after a certain amount of uses ?
Thanks for the vid
Kelvin, which type of refill ink is suitable for HP915xl cartridge? whole set.
My ink cartridges are refilled and put back into printer and it still says they are low. How do i fix this?
Not at all. The levels tell you nothing anyways