Keyless Entry Handle Repair on 2010 Mazda 6 (GH)

Changing the plastic backing on my door handle. What in the heavens could do so much damage to a door handle?
Doorhandle link: www.ebay.co.uk/itm/256358671633
Disclaimer:
Due to factors beyond the control of Klavs, I cannot guarantee against improper use or unauthorized modifications of this information. Klavs assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I, Klavs recommend safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Klavs, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Klavs.

[@Hjelm-Viking]

Again one very good video with a lot of information.

[@KlavsX_]

👍 Glad this video help's✌

[@tonnibusa3519]

Good job 👍🏼

[@KlavsX_]

👍 Thank you

[@studwars123]

thanks for video im just about to change the door handle button in my mazda i'm sure this video will help me with disassembling the door panel

[@KlavsX_]

👍 Good luck to you. it will be quiet a pain , to unplug the connector in the door.

[@studwars123]

I did it today but the button i bought had only 2 wires and original has 6 can't find anywhere with 6 wires maybe i'll try junkyard.
But on video this looks harder than it is .
Cheers

[@KlavsX_]

Good luck and you should be able to find it.
Maybe the 2 wire are only for the button, the rest of the wires go to the sensor that picks up your hand when you grab the handle