There is an o-ring already contained within the connector fitting that attaches to the firewall.....just push the connector onto the fitting and rotate the grey locking tab and you'll be good to go. If you purchase the same part I used, it will come complete with every fitting and connection bracket (which allows the heater hose to either clip onto an adjacent hose or wiring harness). Hope this helps you.
the video contains both the Ford part number (BV61-18K580-KF) and it also contains the part number for the Gates aftermarket hose which I bought and installed. the Gates # is 24859 and is available at O'Reilly's. Note, you have to determine if its the right hand or left hand hose that is leaking because they are very different and have different part numbers. to determine if its the right or left hose you must be looking at the car....right would be driver's side, left would be passenger side. the hose does have two or three integral plastic tube sections and plastic connectors that attache to different points on the vehicle......the Gates hose comes with everything. watch the video again and you should see what I mean. good luck and thanks for watching.
Well done! The perspective descriptions, steady rate of speech, and part numbers were SUPER helpful.
@@lemauser646 thankful I was able to help. Cheers!
That was great thank you! By far the best of the videos on UA-cam for this replacement, and I watched them all!
I'm glad to have been able to help you!!
Thanks. Just discovered my coolant leaking so this was super helpful.
its a pretty simple fix. i do suggest getting the hose disconnect tool though. good luck.
its exactly the video that i been looking for! found it thanks
hopefully the vid was able to help you. Cheers.
Thankful I was able to help you.
Super! This process works perfectly!
Glad to have been able to help you.
On the "final" connection point that goes into the firewall, is there a separate rubber o-ring that goes in it? Or just the connection itself
There is an o-ring already contained within the connector fitting that attaches to the firewall.....just push the connector onto the fitting and rotate the grey locking tab and you'll be good to go. If you purchase the same part I used, it will come complete with every fitting and connection bracket (which allows the heater hose to either clip onto an adjacent hose or wiring harness). Hope this helps you.
Hey bro
Did you know the size of Oring
plz
Where can i find the hose? Or do you have a part number. Everywhere weve looked the hose has an extra piece connected to it
the video contains both the Ford part number (BV61-18K580-KF) and it also contains the part number for the Gates aftermarket hose which I bought and installed. the Gates # is 24859 and is available at O'Reilly's. Note, you have to determine if its the right hand or left hand hose that is leaking because they are very different and have different part numbers. to determine if its the right or left hose you must be looking at the car....right would be driver's side, left would be passenger side. the hose does have two or three integral plastic tube sections and plastic connectors that attache to different points on the vehicle......the Gates hose comes with everything. watch the video again and you should see what I mean. good luck and thanks for watching.
So we all got coolant leaks rn 💀
Sadly….
unfortunately......eventually! Parts just wear out.
Nice orientation guy