I just got my truck out the shop. I replaced the head in all the the gaskets on the front end Orings and gaskets for. Drove it 14 miles to the yard park the truck. drove it the next day about 10 miles to the glass place and back to the yard no problem. Went to drive the truck again. engine low oil light came on. I replace sensor harness and oil sensor. old harness was beat. That wasn't problem. I'm think it the pump.
Good vid bud..preciate the lesson on the oil pump and the oil pan gasket.👊🏿 👊🏿👊🏿 that gasket is a nightmare!! Literally.. What's the best oil pressure ratio on deck should we expect during idle? Thanks again
Not sure the torques are properly applied... it appears he uses an impact wrench to drive the bolts, and then finishes with the torque wrench. This can be VERY BAD PRACTICE because if the impact wrench overtorques the bolt, the torque wrench won't budge the already overtorqued bolts. Looks like the bolts aren't moving with the torque wrench in this video ---- so he's probably already overtorqued the bolts and the wrench will just click on the first application of force. Sure glad he isn't my mechanic!!!!
I just got my truck out the shop. I replaced the head in all the the gaskets on the front end Orings and gaskets for. Drove it 14 miles to the yard park the truck. drove it the next day about 10 miles to the glass place and back to the yard no problem. Went to drive the truck again. engine low oil light came on. I replace sensor harness and oil sensor. old harness was beat. That wasn't problem. I'm think it the pump.
Good vid bud..preciate the lesson on the oil pump and the oil pan gasket.👊🏿 👊🏿👊🏿 that gasket is a nightmare!! Literally.. What's the best oil pressure ratio on deck should we expect during idle? Thanks again
50-80 psi
what are you torqueing the4 oil pump installation bolts.
Yeah the hole reason I was looking at the video was for the torque off the oil pump and pan
WTF!! HOW DO TAKE GEAR OFF THE FRONT OF IT? THERE ARE BUSHINGS To inspect daaaang!!
تووووب
Is it equal to Perkins 2506 Engine oil pump
What’s the torque spec for the oil pan bolts ?
What about the spacer plate? That goes between the block and pan?
Some of these engines have those this one does not.
@@0698gingerich if I install the oil pump would I have to put the spacer plat first like some of them does ?
Does the engine time matter when installing the oil pump?
No it doesn't, but as he showed make sure the gears are meshed properly
Not sure the torques are properly applied... it appears he uses an impact wrench to drive the bolts, and then finishes with the torque wrench. This can be VERY BAD PRACTICE because if the impact wrench overtorques the bolt, the torque wrench won't budge the already overtorqued bolts. Looks like the bolts aren't moving with the torque wrench in this video ---- so he's probably already overtorqued the bolts and the wrench will just click on the first application of force. Sure glad he isn't my mechanic!!!!