thanks! you need to find extra long reach pliers that will reach past the bores that are 3.5inches plus the side of the block. you can also try 90degree pliers and reach from inside the other cylinders. in my case, my long reach pliers were too short so I placed tweezers on to the clips and my used long reach through the top of cyl 1 and 2 to squeeze the tweezers and pull the clip out
Awesome stuff mate. Keen to see her running again!
Great video, thanks. How long and what type of pliers or tool did you need to remove the wrist pin clips from cylinders 3 &4?
thanks! you need to find extra long reach pliers that will reach past the bores that are 3.5inches plus the side of the block. you can also try 90degree pliers and reach from inside the other cylinders. in my case, my long reach pliers were too short so I placed tweezers on to the clips and my used long reach through the top of cyl 1 and 2 to squeeze the tweezers and pull the clip out
I'm doing a very similar build ez30 swap in a gc8
@@patrickhamilton4434 nice! Hope you post some videos of your journey
@@80805stido you have an Instagram or TikTok account
close deck?
@@patrickhamilton4434 unfortunately I cant afford it this time around. Id buy new case halves and have them done if I had the money