My top 5 Radios for FT8 and WSJT-x (I have become hooked on FT-8)
Вставка
- Опубліковано 9 лют 2025
- I had to look into FT-8 and have become hooked, I give my top 5 best radios for FT-8
Please visit my amazon store www.amazon.co....
HV50 Superglue 50g: amzn.to/2UcqSzB
TS100 Programmable Pocket-size Smart Portable Soldering Iron: amzn.to/2YiGuVs
hand deburr tool: amzn.to/2G4yJIf
Tiny 30Amp PSU: amzn.to/2v4b3l2
SDR-Play RSP1A: amzn.to/378KQzH
The Icom IC-7300: amzn.to/2TEctNa
MFJ Antenna analyser: amzn.to/2R7DN4P
Music from Epic Sound: www.epidemicso...
Gary, you come across as a real genuine guy, .... and very easy to follow as you describe what you are doing... love the plain english, and basic way in which you explain... far too many folk go drifting along a totally different path... and thank you for that... I was a little surprised with your No1 choice... but it does show your honesty, especially when you are sitting with a 705 aside you... Keep up the excellent work fella... kind regards... Yoki...
I try :-)) hard sometimes to get things out of my head as it goes wrong on video 😂
Gridtracker is a great addition to your WSJT-X FT8 workings
I'm a full ICOM FT8/FT4 nut.
Use these with great success, 7100, 7300 and 9700, all bands 40m to 23cms
Have now got the 705 but yet to use it on anything but it should be just as good.
It's amazing what can be worked even in the low solar cycle.
One tip.
Keep checking your transmit slot is clear, red goalposts, quite often other strong stations get on top of you
and then blow your chance with DX.
Fab I’ll have a Ganda it’s all rather addictive
Hi Gaz thanks for the video, I use Net time for wsjt-x and install and forget. I notice you are in split mode (fake it) I only use this in dx expedition mode F/H. Thanks and enjoy ft8.
Nice video Gary. I was having fun with FT8 after getting through all the settings setup. Then I upgraded the firmware on my FT-991A and lost all the settings and memories, GRRR!
Hi Garry, look above the waterfall for the small horizontal red line, this shows where you are transmitting in the FT8 spectrum, move this line to a space where there is no activity. This gets more important when the band is busy, then you will be heard better. You can also try the decode modes, normal, deep etc. One idea for a good video is how to remote the 705, so you can use it in another room via your home LAN/wifi, not sure what software there is for this, maybe some one has an SDR application end that could be used?
Thank you Gaz, I also find out exactly what your were cloning. Sorry for that. Greetings - Paul (ON7ARF).
You’re welcome Gaz!
re the comment about ft8 power/pa damage ,hence why i use my 7610 with my spe 1.3kfa, never drive any more than 9% into linears, oh btw kenwood ts590 super easy to setup on ft8/ft4 download kenwood usb sound drivers install cuple of selection in the radio menu one std usb lead ,job done JA qsos galore :)
Good video Gary, just one question, why dont you want to put your output up much and what makes you think you will blow your rig? I use my 705 on FT8 and often run at 10w through an alex loop with no problems.?
I work for a HamRadio outlet, I deal with the repairs and see what ft8 can do to pa transistors and filters ... rule of thumb don’t exceed AM rating of the radio.. Gaz
@@TheGazLab I didnt realise that the output on AM is only 2.5w, just read the manual, but it says SSB is 10w? Or am I missing something else in the manual? I only use FT8, so want to make sure I'm doing it right.
@@sptvids it’s wise to not run you pa’s flat out on ft8.. I can’t tell you how to play radio :-)
Gaz, dont forget to set the audio level to just activate the ALC . I usually set mine one notch below the ALC activation on my 7300. Good luck 👍 73
Okey dokey where am I looking?
@@TheGazLab power level slider , right hand side , Its easy to overdrive the audio with the power level adjustment and cause interference in the ft8 spectrum . 👍👍
@@jeffg8sei thanks for that
@@TheGazLab Another tip is to look at the waterfall and set your audio to a clear slot , then tick the box for " hold tx freq" . 40m , 20m can be a it congested at times and finding a clear audio freq problematic 😀
Great tips from @Jeff G8SEI - Another tip @The Gaz Lab - don't forget to open BandWidth Filter to the full 3.6k so can see the whole of the band on the scope in WSJT-X - Press and hold FIL on 7300 / 705 and then click on BW then use the main dial to adjust. M7KWB - 73
i was hooked on ft8 but now hooked on cw ,,,still learning lol
I have a IC7300 and a FTDX3000 I prefer the FTDX3000 for simplicity
Hi You mentioned the 330S antenna and said it was good for RX, how was it on TX and you also mentioned the BT6W but did not expand on its performance, I have tried to find it but no luck was it a BTV-6?
The wd330s is a good all around antenna I was very impressed considering it’s size.. the bb6w is awful on TX .. hope that helps.. gaz
@@TheGazLab Cheers and keep up the good work on your UA-cam channel
Great video Gaz...(doh, what do we call you after the revelation of the only fools “Strangers on the Shore” episode 🤦♂️😂)
Not really played with FT8 so this nudges me along, thanks 👍👏👏
I asked my 6 year old niece to choose a new name.. she 10 now and not decided yet lol 😂
@@TheGazLab 😂
I will use it as a propagation tool, or for some weak stations that are 10,000kms from me, but no interest in just filling up a logbook with those that I can just pick up the microphone to... working EU on FT8 has zero interest to me...
It is described as being designed for "multi-hop Es where signals may be weak and fading, openings may be short, and you want fast completion of reliable, confirmable QSO's"
To sync my time I just use time sync. Just install and forget
Nothing wrong with "Gary" !
I do hope not 😂
I know how u feel mate lol I also got loads of stick over the film called snatch and one of Bricktops lackys called Gary lol and the famous saying "pull your tongue out of my xxxe xxxx Gary" haha not nice and to make it worse my own daughter used to laugh the loudest.
who said that? you did not say who you were ??? you are the best guy in M Lynch`s shop.the rest , ???
Fy-8 anytone 878
whats up?? Gaz
Working on FT-8 is like calling someone on a cell connection anyone can do it .Try working rare DX on SSB phone whole different ball game..
Yep done it a few times very stressful.. Gaz
$1000+ and still need compter...
As far as I know that’s the case.. depending on your view most new radios have a computer inside, so no getting away from it really.. closest you will get to an all in one solution would be the sun sdr MB1..