Yanko Dimitrov ball bearing drawer slides are better mounted on center or top rather than bottom side , in center it’s best so that minimal play is there and damages due to wear and tear is also less.
its not that easy the WIDTH is measured for for roller runners not bearing ITS NOT STRAIGHT CHANGE the width is not the same lack of techincalities.you will end up SLEEVING
I thought you would have shown how to allow for the fall of the old drawer runner.
Good
in mark first drilling position in 1.45, you mean 1.45 inch?
That song is fucking hot fyre guys thanks
why not use the same mounting location as the roller ones?
Yanko Dimitrov ball bearing drawer slides are better mounted on center or top rather than bottom side , in center it’s best so that minimal play is there and damages due to wear and tear is also less.
C'est l'autre table importe
Hello! Do you have a question for us? 🙂
Is this difficult to do with kitchen/bathroom cabinets?
It would be pretty much the same
its not that easy the WIDTH is measured for for roller runners not bearing ITS NOT STRAIGHT CHANGE the width is not the same lack of techincalities.you will end up SLEEVING