Husqvarna 525P4S pole saw/pole pruner carburetor and fuel system repair.
Вставка
- Опубліковано 29 сер 2024
- Husqvarna pole saw carburetor repair. A step by step how to including carburetor, fuel hose, primer bulb, fuel filter, and air filter replacement. This applies to the Husqvarna 525P4S pole pruner/pole saws and Husqvarna weed trimmers.
This was a great help to me. I realized through watching that I was also missing a gasket. Thank you.
Best vid on UA-cam for this repair!! Thx a lot.😊
Heck yeah man easy to follow and the step by step is great. Now instead of just a replacement how about salvaging an old throttle trigger handel and the adjustment of the vibration control, tight or loose, tried both one is worse than other the other,
Seriously the best instructional video I’ve ever watched!!! Thank you amazing what knowledge can do to improve instruction. Bravo
I looked all of the place to find why the throttle cable was so slack. You just showed me what I was doing wrong. Thank You!
Here for the exact same thing lol glad I found this
Thank you Sir.
Very helpful
GOOD VIDEO, I TYPICALLY FIND IT EASIER TO REMOVE THE SURROUNDING FAIRINGS AND GIVES A LITTLE BETTER ACCESS.
I appreciate the comment and you watching. I’ll definitely try that. Appreciate the advice.
I appreciate the comment and you watching. I’ll definitely try that. Appreciate the advice.
👍👍👍
It takes me longer than twenty minutes to get it cussed good and proper.
Lol
Saved me 80/hr. Cost me parts and a few tall boys.
I have a husqvarna 535ls Only had it 1 year. Went to start it up after doing routine maintenance ie replacement spark plug and gapped correctly. Clean air filter Had been stored cleaned and fuel stabilizer for the winter. So on start up. The engine comes to life and dies immediately when pushing in the choke. The air purge valve I noticed does not fill with fuel. Just stays empty after several pumps. Would this be a bad air purge bulb or carburetor issues? I let the engine run on the choke until it warmed up yet still engine dies when pushing in the choke. Appreciate any help
Carb issue. I would take the top of the carb off and check to see that the metering diaphragm is not stiff. It should be flexible.
Carb issue. I would take the top of the carb off and check to see that the metering diaphragm is not stiff. It should be flexible.
@@lesteroliveintheshop9825 thank you for your comment. Yes you were correct. It was the diaphragm metering Apparently at the authorized dealer said that there was a recall on this part. And was affecting many models of the Husky and stihl As they are made by same supplier!!! Got it repaired free!
Hi what parts number you used to order?