Front Fork Removal and Cap_0001.wmv

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 15

  • @AngliaNutz
    @AngliaNutz 6 років тому

    Thank you for taking the time to produce and provide your videos

  • @zero2stang
    @zero2stang 9 років тому

    Just curious if you know if this is the same/similar. I have a 1999 Dyna Low rider with the narrow glide front end and have been thinking of putting a mid glide conversion kit on. Just take off the fender, wheel and calipers slide out the fork tubes and slide new ones in place into the new trees?

  • @authentic4225
    @authentic4225 3 роки тому

    How far should forks sit on upper tripple tree?

    • @rscrod
      @rscrod  3 роки тому

      From top of tree to top of the flange on the bolt. Measures .250 to .380 of inch. Lowering the front end then same measurement to 1 inch. Pinch bolts torque to 31-34 ft-lbs

    • @authentic4225
      @authentic4225 3 роки тому

      @@rscrod Do you happen to know the ft-lbs front break pads?

  • @garrettblackwell2335
    @garrettblackwell2335 8 років тому

    hey I want to just change the fork oil on my 2003 V ROD. I am only worried about making sure I put them back on correctly. Is there sure fire way to know i am putting them back on the correct way and or the right hight?

    • @rscrod
      @rscrod  8 років тому

      Read the book. It is easy. people run the tube up 1 inch to lower the front end. If yo want to go stock. just measure the height out of tree and put it back in. If you are off just a tad, no big deal. Remeber the forks absorbs up and down.

  • @Houseofhorsepower
    @Houseofhorsepower 11 років тому

    what weight do you do you recommend to make it siffer

  • @johnnygoodlife
    @johnnygoodlife 8 років тому

    Great video. Thanks for uploading. Going to do this very soon.

  • @1supermanprime
    @1supermanprime 8 років тому +1

    how do you remove those chrome caps that are on the sliders? the ones that cover the seals. I can see no type of notch on mine.

  • @rscrod
    @rscrod  9 років тому

    double check what your manual says

  • @rscrod
    @rscrod  8 років тому

    use small rubber mallet and tap it up.

  • @rscrod
    @rscrod  11 років тому

    Harely heavy oil...
    Not the extra heavy.

  • @guillermolayedra2514
    @guillermolayedra2514 6 років тому

    Me gusto mucho la explicación, me fue muy útil

    • @rscrod
      @rscrod  6 років тому

      Your welcome