Ortur

Hi, today I will engrave a photo of a Dodge Hell Cat SRT on to a 30x20cm mirror, then install it into light box fitted with 2.4m of full RGB LED's, all will be done using the Ortur laser master 3LE 10W machine, please if you fine this video to be of any use to you then please hit the LIKE & SUBSCRIBE button. #laser master 3
Thank you.
Please check out links below.
If you're interested in purchasing the Ortur laser master 3 LE engraver or software I use, please check out the links below.
Official Ortur Discount code:
OLM3 LE: 60FORLASER
Accessories: 10FORLASER
My Facebook page where you can see many examples of work done:
/ lightworkz.graphicdesign
• Laser Engraving
Ortur laser master 3 / laser master 3 LE:
ortur.net/prod...
Software that I would recommend:
ImagR: www.imag-r.com/
Lightburn: lightburnsoftw...
@ImagR-Laser @ORTUROFFICIAL @HouseOfLasers @LaserLivestream @LaserEngraving911 @orturnet
#laser #engraving #ortur #laserengraving #lasermarkingmachine #lasermaster3 #glassengraving #engravingmachine #orturlasermaster2 #glassengraving #gifts #engraving #engravingmachine #facebook #lasercutting #orturlasermaster2

[@ltrick2387]

WOW! What a fantastic project!

[@lightworkz61]

Hi and thanks ;)

[@lles3D_Studio]

sehr gut 👍👍

[@lightworkz61]

Hi and thanks ;)

[@robertdutton6110]

Very well explained Thankyou.

[@lightworkz61]

Thanks mate ;)

[@William_Van_Landingham_III]

Excellent work! Subbed.

[@lightworkz61]

Hi & many thanks ;)

[@lightworkz61]

Thank you ;)

[@SieliececeliaMuller-pg5km]

Dis is baie nice en goed gedoen

[@lightworkz61]

Thank you ;)

[@johndavis3894]

Excellent project. It's motivation for sure.
Where did you get the mirror, and what specific mirror did you use?

[@lightworkz61]

Hi & thanks ;) the mirror is just a standard cheap 30x20cm x 3mm thick mirror that I bought from Jumbo here in Cyprus, a pack of four was just €5, many thanks for the comment.

[@jamesjacob2264]

Is it possible to get this perfectly done by using laser explorer instead of light burn, and get great results as this? (After processing the image through image-r)
Or can you try on the other piece and we compare how far that basic app can take through a biginer since lightburn may look a bit complex.
Thanks in advance
It was a great work 👏

[@lightworkz61]

Hi, sorry I can't use the app as I don't have access to WiFi in my work place, my PC has a direct fiber connection, sorry.

[@josp60]

hi very beautiful! What laser settings did you use?

[@lightworkz61]

Hi & Thanks ;) in Lightburn I used Speed=5000 Power=70 Dpi=317 Scan angle=0 Image processing in ImagR, I hope this helped, all my settings are shown in the vid ;) Thanks.

[@josp60]

@@lightworkz61 thank you

[@jose.luis.blancas]

You laser is CO2 or diode laser ?

[@lightworkz61]

Hi & thanks, I made that mirror box using my Ortur LM3 10w, blue diode machine.