Below are my affiliate links to the tools you would use to complete this job. I may receive a small commission from the product sales. Thank you! Transmission jack: amzn.to/3zGgXKA Truck jack stands: amzn.to/3q6VS7t 36" pry bar: amzn.to/3xURDjf Large punch set: amzn.to/3XWLuO4 1/2" drive cordless impact wrench kit: amzn.to/3Kcw00I 3/8" drive flex head digital torque wrench: amzn.to/3O1EOru Rechargeable LED mini work light: amzn.to/3Y74OpY
These videos are greatly appreciated. I'm trying so hard to hardwire a dash camera that has constant power to it so I can use it for motion detection. Would you know where I could hardwire it? Thanks.
@@Viktor_G_Automotive cool iam putting in a use tranny i dinit know if i should put new seals in or not i see you put yours back in without replacing seal
@@jakeblue8506 it depends on your situation. If you have a hoist and are ok with pulling parts out if something leaks down the road, you can skip replacing the seals. However, if you don’t want the hassle of removing the components again, definitely replace the seals.
Below are my affiliate links to the tools you would use to complete this job. I may receive a small commission from the product sales. Thank you!
Transmission jack: amzn.to/3zGgXKA
Truck jack stands: amzn.to/3q6VS7t
36" pry bar: amzn.to/3xURDjf
Large punch set: amzn.to/3XWLuO4
1/2" drive cordless impact wrench kit: amzn.to/3Kcw00I
3/8" drive flex head digital torque wrench: amzn.to/3O1EOru
Rechargeable LED mini work light: amzn.to/3Y74OpY
These videos are greatly appreciated. I'm trying so hard to hardwire a dash camera that has constant power to it so I can use it for motion detection. Would you know where I could hardwire it? Thanks.
@@jt8084 if you want constant power, you could just wire it to the battery.
Hi Viktor. I have lx 570 can I reach 2 upper top bolts without lowering the entire transmission Tcase assemble?
@@vasya6175 yes, you can with an extension and a swivel.
@@Viktor_G_Automotive wow you answered so quickly, didn't expected. I will try soon and report back, thank you
@@vasya6175 no problem!
did you put new oil seal in when you instal
@@jakeblue8506 I have replaced them before, but not on this particular unit.
@@Viktor_G_Automotive cool iam putting in a use tranny i dinit know if i should put new seals in or not i see you put yours back in without replacing seal
@@jakeblue8506 it depends on your situation. If you have a hoist and are ok with pulling parts out if something leaks down the road, you can skip replacing the seals. However, if you don’t want the hassle of removing the components again, definitely replace the seals.
how long did the whole process take?
@@timbeaton4811 if I don’t run into anything seized etc, it takes me less than 2 hours to get the t-case out and back in.
Where are you located
@@rajandraram2074 Alberta, Canada