1946 John Deere BN - Auction Find 3
Вставка
- Опубліковано 6 тра 2024
- 1946 John Deere B N; Can we save it? Carburetor, operating temperature, governor linkage adjustment, throttle linkage adjustment, cold start, startup, first test drive. #johndeere #johndeeretractor #willitrun #willitstart #antiquetractor #subscribe
• 1946 John Deere BN - A...
• 1946 John Deere BN - A...
For advertising inquiries, please use antiquecarsandstuff@gmail.com
Check out our new Facebook group and post photos and videos of your own stuff! / 214615154475094
"F.A.C.T.S. Fuel. Air. Compression. Timing. Spark." TM Trademark, Antique Cars and Stuff 2024. - Авто та транспорт
Another fun old tractor adventure! Thanks for taking us along.
My pleasure!
Nice 👍
I enjoyed the video! That oil was something else!!
Thanks my friend!
Very glad you’ve got it sorted, boy did it need an oil change! that’s one heck of a big tractor for such a small two cylinder engine!
Yes it did. That oil was nasty!
Those engines aren't really that small. They have a 4 1/2 inch bore with a very long stroke. They're close to 200 c.i.
Nice job she sounds sweet!
Those old dinosaurs draining out of the engine looked like they've been in that pan since the Eisenhower administration. Nice job it runs pretty sweet.
Ha ha! Thanks!
Great job It’s fun to see old tractors run again
Thanks 👍
My 39 B runs 185 in the summer, in cooler weather in have to close the shutters to keep up the temp, I never put a load on it, looks like you have a nice tractor
I guess they just tend to run cool. Thanks!
Looking forward to the generator rebuild.
Generator or paperweight? We will find out.
She sounds good, except the small screeching sound. It looks like you will address that eventually. That B definitely needed some TLC since it looks like it's been neglected for some time. I love those old Johnny Poppers and wish I had an old B, even an H.
If you are idling much, set the brakes and engage the clutch. There’s a bearing inside the clutch that is not being used when the clutch is engaged.
Very good. Thank you.
There is probably a good chance that if you take the tin cover off the generator and lube the brush holders and also oil the front and rear bushings under the 2 spring loaded caps on the front and back your generator will most likely stop squeaking.
Thanks!
Trick I use to do fill with diesel start run for like 30 seconds drain oil/diesel repeat until clean then fill with oil
Yes, that works well!
Then run about 1 quart of marvels mystery oil and 6 1/2 quarts of oil. That will, possibly, free up the rings
you need to replace the bushings in the generatot maybe just a little oil
Ok thank you.
Just curious, what did the rebuilt carburetor cost if you don't mind me asking? Great video.
Thanks. Roughly $330 after the core exchange.
That’s cheap, some sources are about $600- $960.