Thank you so much for making this video. I followed Powrtouch instructions for removing the cover, they never mentioned doing what you did. Now I know. Thank you. 👍👍👍
Glad i came across you. I was operating lever to engage movers, Heard a bang on the other mover, Now its stuffed. I undone hexagon bolt and thought the cover would come off..... Oh no no no!! Because of you , i now know, So simple. Do tomorrow i van investigate the broken!?!? Internal part.
Hi great video I'm fitting one of these to my caravan now I'm just wondering how big is the gap between the motor mover and wheels before it is engaged thanks
Hi Richard, excellent video and thank you. However a question if I may. I need to replace the inner and outer bearings but removing them is not easy, any tips?
Glad you found the video useful. I used lots of WD40 and different screwdrivers. Firstly I used a levering action between the roller and the bearing, then as it opened up a bit a twisting action and finally a chiselling action with a light hammer and broad screwdriver - always rotating the shaft after each strike so the bearing didn’t bite into the shaft. I may have been lucky and guilty of tool abuse!
Hi - you can only remove the roller by completely dismantling the mover. There is a bolt through the gear inside the housing through into the end of the roller so you can never just pull/wack it out after removing the “3 bolt” roller end cover. Does that answer your question?
This is exactly the video I needed to find. Thanks
Thank you so much for making this video. I followed Powrtouch instructions for removing the cover, they never mentioned doing what you did. Now I know. Thank you. 👍👍👍
I’m trying this tomorrow so this has been very helpful!!!
@@jimmystobbart6968 good luck - and expect to get grubby!
This is a job that I need to do but had no idea how to go about it , thank you for posting this.
Glad i came across you.
I was operating lever to engage movers,
Heard a bang on the other mover,
Now its stuffed.
I undone hexagon bolt and thought the cover would come off.....
Oh no no no!!
Because of you , i now know,
So simple.
Do tomorrow i van investigate the broken!?!? Internal part.
@@rawiriadair9595 good luck - prepare to get dirty crawling under the caravan and then encountering all the grease!
Great video Richard, I’ll drop my van of later for new bearings.❤
😆
Hi great video I'm fitting one of these to my caravan now I'm just wondering how big is the gap between the motor mover and wheels before it is engaged thanks
This link will show you the different values based on model number: www.powrtouch.com/roller-gap-adjustment/
Hope that helps- and good luck!
Helpful video, many thanks.
Very helpful Richard. Thank you.
Hi Richard, excellent video and thank you. However a question if I may. I need to replace the inner and outer bearings but removing them is not easy, any tips?
Glad you found the video useful. I used lots of WD40 and different screwdrivers. Firstly I used a levering action between the roller and the bearing, then as it opened up a bit a twisting action and finally a chiselling action with a light hammer and broad screwdriver - always rotating the shaft after each strike so the bearing didn’t bite into the shaft. I may have been lucky and guilty of tool abuse!
How did you remove the roller?
Hi - you can only remove the roller by completely dismantling the mover. There is a bolt through the gear inside the housing through into the end of the roller so you can never just pull/wack it out after removing the “3 bolt” roller end cover. Does that answer your question?
@@MrRichardmorris yes. I had it dismantled, it just needed a couple of whacks with a hammer to get the spline of the roller to release. 👍 Thanks.
@@themorfill Brilliant!
Thanks pal 🎉