Finally the numbers are in 4.6 3valve swap foxbody dyno run

so finally we were able to get it done....the 3valve swap foxbody is tuned an made some good numbers for a N/A setup so stay tuned
tuned by rodeheavers's hot rod shop

[@jameshornsby8115]

You couldn't by chance take a picture of your motor mounts where they bolt to the engine and to the k member it would be greatly appreciated thank you

[@jameshornsby8115]

Hello again this is the guy putting the 2008 3-valve into his foxbody I still can't find motor mounts you said in our previous conversation that you use modular motor mounts do you remember where you bought them the only ones I can find have three holes to bolt to the engine but the stock motor mounts have four holes how did you solve that

[@brezicky]

I'm using aje k member with there mounts

[@brezicky]

ajesuspension.com/product/4-6-and-coyote-engine-mounts/

[@jameshornsby8115]

And they lined up with all four holes on the engine block including the offset one

[@jameshornsby8115]

Though I think that only one side has the offset hole

[@brezicky]

@@jameshornsby8115 yeah that's what I got ..mine are from like 2013 or around then but shouldn't be any different...put bolts in loose then tighten all ...if not open the holes up a little

[@mistersecret88]

Nice. What color is that? I have a vert too

[@brezicky]

Thanks an that's what's up....yeah it's some color I mixed up wit some leftovers years ago lol I call it ghost grey

[@2006Mercury]

Would look good on my Grand Marq